You are not logged in.
Pages: 1
hi,
my laptop cpu is overheating all the time
cpupower service failed to start due to configuration.
this is my configuration
# Define CPUs governor
# valid governors: ondemand, performance, powersave, conservative, userspace.
governor='powersave'#ondemand
# Limit frequency range
# Valid suffixes: Hz, kHz (default), MHz, GHz, THz
min_freq="800MHz"
max_freq="2.6GHz"
# Specific frequency to be set.
# Requires userspace governor to be available.
# Do not set governor field if you use this one.
#freq=
# Utilizes cores in one processor package/socket first before processes are
# scheduled to other processor packages/sockets.
# See man (1) CPUPOWER-SET for additional details.
#mc_scheduler=
# Utilizes thread siblings of one processor core first before processes are
# scheduled to other cores. See man (1) CPUPOWER-SET for additional details.
#smp_scheduler=
# Sets a register on supported Intel processore which allows software to convey
# its policy for the relative importance of performance versus energy savings to
# the processor. See man (1) CPUPOWER-SET for additional details.
#perf_bias=
# vim:set ts=2 sw=2 ft=sh et:
output of cpupower frequency-info
analyzing CPU 0:
driver: intel_pstate
CPUs which run at the same hardware frequency: 0
CPUs which need to have their frequency coordinated by software: 0
maximum transition latency: 0.97 ms.
hardware limits: 800 MHz - 2.90 GHz
available cpufreq governors: performance, powersave
current policy: frequency should be within 800 MHz and 2.90 GHz.
The governor "powersave" may decide which speed to use
within this range.
boost state support:
Supported: yes
Active: yes
25500 MHz max turbo 4 active cores
25500 MHz max turbo 3 active cores
25500 MHz max turbo 2 active cores
25500 MHz max turbo 1 active cores
Last edited by shalaby (2014-04-14 14:22:20)
Offline
This post is missing a lot of information.
- I might have missed it, but can you list more about the hardware? What processor do you have, physical/virtual cores (looks like 4 cores), etc.?
- Typical temperature/frequency readings when the overheating occurs (you can install lm_sensors). You can get cpu frequency with:
$ cat /sys/devices/system/cpu/cpuN/cpufreq/cpuinfo_cur_freq # replace N with cpu number to check
- What is the negative outcome of the overheating is (just hot, or is it shutting down?)
- What did you change in the config file from the default?
- What is the output of `systemctl status cpupower.service`?
- Have you run `systemctl enable cpupower.service` or are you simply manually starting with `systemctl start cpupower.service`?
- I haven't used cpupower, but did you see the the note on the Arch wiki that starting at boot will result in a failed service message?
I saw this as I was having a similar issue. Here's the information I provided to help others troubleshoot with me.
Offline
Pages: 1