You are not logged in.
From a virtual console (excluding X problems) I do `systemctl suspend` or close laptop lid.
Expected behaviour: laptop wakes up when I tap space button
Actual behaviour: reinserting battery is only way to wake it up.
Not even holding down power button yields a response. Here is log from boot:
http://bpaste.net/show/379150/
Laptop is a packard bell intel atom CPU Z520 1.33GHz with gfx card: Intel GMA 500 series, also known by it's codename Poulsbo.
How can I debug this further?
Offline
Look at
cat /proc/acpi/wakeup
to see what acpi events are enabled. It seems like from your journal logs that LID is registered so does it wakeup when you open the lid?
Offline
Opening lid do not wake it up. The only way to make laptop usable again is reinserting battery.
Device S-state Status Sysfs node
AZAL S3 *disabled pci:0000:00:1b.0
P0P1 S4 *disabled pci:0000:00:1e.0
EHC1 S3 *enabled pci:0000:00:1d.0
USB1 S3 *disabled
USB2 S3 *disabled
USB3 S3 *disabled
USB4 S3 *disabled
EHC2 S3 *enabled pci:0000:00:1a.0
USB5 S3 *disabled
USB6 S3 *disabled
USB7 S3 *disabled
RP01 S4 *disabled pci:0000:00:1c.0
PEG5 S4 *disabled
Last edited by Discully (2014-06-17 02:58:44)
Offline
Try adding lid and power button to /proc/acpi/wakeup like so:
sudo bash -c 'echo LID > /proc/acpi/wakeup'
sudo bash -c 'echo PWRB > /proc/acpi/wakeup'
Offline
After running those two commands, suspend to RAM stopped working. What instead happened is frozen screen with terminal marker frozen top left and full power on. But holding down power button for a few seconds did reboot.
Offline