Arch Linux

derive

Member

Registered: 2015-02-02

Posts: 1

Fan control unable to display RPM

Hi,

I've been following this, but I've run into a problem. I cannot seem to find my chipset in /etc/sensors3.conf. Here is the output from lm-sensors:

radeon-pci-0100
Adapter: PCI adapter
temp1:        +60.5°C  (crit = +120.0°C, hyst = +90.0°C)

coretemp-isa-0000
Adapter: ISA adapter
Physical id 0:  +44.0°C  (high = +85.0°C, crit = +105.0°C)
Core 0:         +38.0°C  (high = +85.0°C, crit = +105.0°C)
Core 1:         +41.0°C  (high = +85.0°C, crit = +105.0°C)
Core 2:         +40.0°C  (high = +85.0°C, crit = +105.0°C)
Core 3:         +44.0°C  (high = +85.0°C, crit = +105.0°C)

I'm really not sure how I should go about displaying my fan RPM from here. If anybody is interested in helping me solve this I can provide any hardware details requested.

onslow77

Member

Registered: 2014-09-21

Posts: 283

Re: Fan control unable to display RPM

Hello,

Check if you missed any of the below

1. Did you follow this: https://wiki.archlinux.org/index.php/Lm_sensors before you sat up fan control?

2. If you did, maybe this is what you need: https://wiki.archlinux.org/index.php/fa … ng_fan_div

3. During lm_sensors setup - did you had any errors?

4. Make sure the modules from lm_sensors is started correctly as discussed in this thread: https://bbs.archlinux.org/viewtopic.php?pid=1251766

Regards
Martin