You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2015-02-12 10:18:32
- jgorauskas
- Member
- From: Reno, NV USA
- Registered: 2015-02-12
- Posts: 1
Boot -> Crash loop after update
My system is on an endless Boot -> Crash loop after doing an update. I get a single error message of "[FAILED] Failed to start Load Kernel Modules" and then shortly after that the system just reboots. My HDD is encrypted. How can I find more information about what is causing the crash? Can I skip loading modules during boot? How could I boot with a USB stick and then open the encrypted disk?
Any pointers are much appreciated!
Offline
#2 2015-02-12 12:38:27
- Trilby
- Inspector Parrot
- Registered: 2011-11-29
- Posts: 29,535
- Website
Re: Boot -> Crash loop after update
I have no experience with full disk encryption, so I can't help with that. But this wiki page will give you many approaches to gather more information. The "break=y" at least would be a good test.
"UNIX is simple and coherent..." - Dennis Ritchie, "GNU's Not UNIX" - Richard Stallman
Online
Pages: 1