Arch Linux

satriani

Member

Registered: 2015-06-26

Posts: 27

USB3 issue, can't mount USB Stick

Hey folks,
I can't mount my USB3 Stick "Mach Xtreme Technology FX 32GB"
journalctl -f shows me the following:

Aug 17 09:15:13 MY-PC kernel: usb 4-1: Set SEL for device-initiated U2 failed.
Aug 17 09:15:13 MY-PC mtp-probe[20322]: checking bus 4, device 2: "/sys/devices/pci0000:00/0000:00:14.0/usb4/4-1"
Aug 17 09:15:13 MY-PC mtp-probe[20322]: bus: 4, device: 2 was not an MTP device
Aug 17 09:15:13 MY-PC kernel: usb-storage 4-1:1.0: USB Mass Storage device detected
Aug 17 09:15:13 MY-PC kernel: scsi host8: usb-storage 4-1:1.0
Aug 17 09:15:18 MY-PC kernel: usb 4-1: Set SEL for device-initiated U1 failed.
Aug 17 09:15:24 MY-PC kernel: usb 4-1: Set SEL for device-initiated U2 failed.
Aug 17 09:15:24 MY-PC kernel: usbcore: registered new interface driver usb-storage
Aug 17 09:15:24 MY-PC kernel: usbcore: registered new interface driver uas
Aug 17 09:15:24 MY-PC colord-sane[20335]: io/hpmud/musb.c 2079: Invalid usb_open: Permission denied
Aug 17 09:15:24 MY-PC colord-sane[20335]: io/hpmud/musb.c 2079: Invalid usb_open: Permission denied
Aug 17 09:15:31 MY-PC gnome-session[17256]: (gnome-shell:17310): GLib-GObject-WARNING **: gsignal.c:2569: instance '0x4fb7ec0' has no handler with id '1'
Aug 17 09:15:40 MY-PC kernel: usb 4-1: reset SuperSpeed USB device number 2 using xhci_hcd
Aug 17 09:15:45 MY-PC kernel: usb 4-1: device descriptor read/8, error -110
Aug 17 09:15:45 MY-PC kernel: usb 4-1: reset SuperSpeed USB device number 2 using xhci_hcd
Aug 17 09:15:50 MY-PC kernel: usb 4-1: device descriptor read/8, error -110
Aug 17 09:15:50 MY-PC kernel: usb 4-1: USB disconnect, device number 2

Here are some lsusb outputs

Thanks in advance for your help.

Last edited by satriani (2015-08-17 08:19:54)

BTPankow

Member

Registered: 2015-08-28

Posts: 2

Re: USB3 issue, can't mount USB Stick

I've had a similar issue before where I got error -110 when using any usb 3.0 drive.  It turns out my power supply was faulty.  I swapped it out and I was able to see and mount my drive.  If you're on a desktop, that may be worth checking out.

Do you get this error with any other usb 3.0 drives or usb 2.0 drives?  Is it just this specific drive?

Head_on_a_Stick

Member

From: The Wirral

Registered: 2014-02-20

Posts: 9,003

Website

Re: USB3 issue, can't mount USB Stick

https://bbs.archlinux.org/viewtopic.php?id=149384

---

Jin, Jîyan, Azadî