Arch Linux

Opticuhl

Member

Registered: 2015-11-03

Posts: 1

Wacom One CTL-471 Proximity Issue

I've got a "One by Wacom" CTL-471 (Small) and it seems to be working fine under Linux except for that distance you can lift and have it still track the pen feels very low (much lower than on Windows).
This is a major issue for me as I use the tablet for Osu .

I've tried this command as it's shown on the Linux Wacom wiki

xsetwacom get "Wacom Bamboo One S Pen stylus" CursorProximity 100

Only for it to output

Property 'Wacom Proximity Threshold' does not exist on device.

Here's a list of the devices shown by xsetwacom.

[user@Arch ~]$ xsetwacom list devices
Wacom Bamboo One S Pen stylus   	id: 8	type: STYLUS    
Wacom Bamboo One S Pad pad      	id: 9	type: PAD       
Wacom Bamboo One S Pen eraser   	id: 18	type: ERASER

Thing to note, there's no eraser support on this device (Not sure if this is relevant).
Any help or suggestions you guys can throw at me would mean a lot to me <3

I'm thinking that the drivers may be setting the proximity (on the z axis) value lower than the hardware is capable of by default which does not occur on Windows.

UPDATE: I also tried using input-wacom-dkms from the AUR. This removed "Wacom Bamboo One S Pen pad" from being displayed but otherwise it's the exact same.

Last edited by Opticuhl (2015-11-03 16:09:51)