You are not logged in.
I have recently installed Arch Linux on a Thinkpad T450 with UEFI SecureBoot enabled. I followed the wiki, particularly the UEFI Secure Boot section. I should mention that I am dual booting Windows 10 as well, so I am using the existing UEFI partition when I install.
Now, I can boot into my Arch installation afterwards. However, I keep seeing the message that SecureBoot fails with this error message:
"Image failed to verify with *ACCESS DENIED*. Press any key to continue [OK]"
This happens twice. After pressing enter the first time, I am then presented with the boot menu (from which I can select Arch Linux). After selecting Arch Linux, it happens again, and when I press enter, it boots as usual.
I'm wondering if anyone has encountered a similar issue? If so, did you manage to solve it?
Offline
Have you switched off secure boot in your firmware settings?
edit: bios =/= firmware settings
Last edited by navi_se (2016-01-06 21:32:52)
Offline
Have you switched off secure boot in your bios firmware settings?
Fixed that for you.
Offline
I'm wondering if anyone has encountered a similar issue?
Yes.
See https://bbs.archlinux.org/viewtopic.php?id=202714
We didn't find a solution
Jin, Jîyan, Azadî
Offline
Thanks for checking everyone .
@Head_on_a_Stick: That indeed sounds very similar (if not the same) to what I am experiencing.
I ended up disabling SecureBoot eventually for now. More like a workaround than a solution, but I'll just have to wait for now I guess.
Offline
IHMO disabling Secure Boot is more THAN a solution...
Offline