You are not logged in.
bob$lsusb
Bus 001 Device 012: ID 0fe6:9702 Kontron (Industrial Computer Source / ICS Advent)
bob$dmesg | tail
[ 716.890484] usb 1-2.3: new full-speed USB device number 12 using xhci_hcd
[ 716.973255] usb-storage 1-2.3:1.0: USB Mass Storage device detected
[ 716.973770] scsi host2: usb-storage 1-2.3:1.0
[ 717.980192] scsi 2:0:0:0: CD-ROM Supereal VR DISK 1.00 PQ: 0 ANSI: 0
[ 717.983799] sr 2:0:0:0: [sr0] scsi3-mmc drive: 126x/126x writer cd/rw xa/form2 tray
[ 717.984900] sr 2:0:0:0: Attached scsi CD-ROM sr0[bob]$ sudo usb_modeswitch -v 0fe6 -p 9702 -d 1
Look for default devices ...
product ID matched
Found devices in default mode (1)
Access device 014 on bus 001
Get the current device configuration ...
Current configuration number is 1
Use interface number 0
USB description data (for identification)
-------------------------
Manufacturer: not provided
Product: USB 2.0 10/100M Ethernet Adaptor
Serial No.: 00002550
-------------------------
Detach storage driver as switching method ...
Looking for active driver ...
OK, driver detached
-> Run lsusb to note any changes. Bye!Last edited by mich04 (2017-01-11 23:25:50)
I love computers, networking and Arch Linux. Sometimes I might ask a stupid question, but please have grace with me like I would with you.
Offline
I believe there is in kernel support for a lot o the older ASIX hardware. What is your's supposed to be?
Offline
I apologize I returned this device and bought I new one. This was a usb to ethernet adapter from Radioshack.
I love computers, networking and Arch Linux. Sometimes I might ask a stupid question, but please have grace with me like I would with you.
Offline