You are not logged in.
I'm trying to create a RAID0 from two identical hard disks. The disks are /dev/sdc and /dev/sdg.
I partitioned each disk with gdisk. This is the partition table print:
Disk /dev/sdc: 976773168 sectors, 465.8 GiB
Logical sector size: 512 bytes
Disk identifier (GUID): 34188C22-446D-4BE5-9E25-A03A9603EC33
Partition table holds up to 128 entries
First usable sector is 34, last usable sector is 976773134
Partitions will be aligned on 2048-sector boundaries
Total free space is 2014 sectors (1007.0 KiB)
Number Start (sector) End (sector) Size Code Name
1 2048 976773134 465.8 GiB FD00 Linux RAIDHere's how I'm trying to create the array.
Zero superblock on each disk:
mdadm --zero-superblock /dev/sdc1
mdadm --zero-superblock /dev/sdg1Create the array:
mdadm --create --verbose --level=0 --metadata=1.2 --raid-devices=2 /dev/md1 /dev/sdc1 /dev/sdg1But mdadm reports errors:
mdadm: chunk size defaults to 512K
mdadm: Defaulting to version 1.2 metadata
mdadm: RUN_ARRAY failed: Invalid argumentI do still end up with a device at /dev/md1 (doesn't seem like I can activate it) so in between attempts I remove it:
mdadm --stop /dev/md1
mdadm --remove /dev/md1The only advice I can find online is:
If you receive an error, such as:
"mdadm: RUN_ARRAY failed: Invalid argument"
make sure your kernel supports (either via a module or by being directly compiled in) the raid mode you are trying to utilize.I'm using a 'stock' arch kernel and I believe it does support RAID0 but I don't know how to verify that.
Thoughts? Other info I should share?
Thanks.
EDIT: Cross-posted on stackoverflow: http://unix.stackexchange.com/q/355895/67136
Last edited by khouli (2017-04-04 16:03:22)
Offline
The directory '/lib/module/$(uname -r)' was missing so the RAID0 module couldn't load. I'm not sure, but maybe a kernel update caused this by removing the module directory for the still running kernel?
Offline