You are not logged in.

#1 2017-05-12 16:03:32

freyr
Member
From: Hungary
Registered: 2010-02-04
Posts: 131

iPXE Netboot won't work - Connection reset (http://ipxe.org/0f0a6039)

Hi!

I wanted to give a try to the Netboot but for some reason it won't work.
I created a USB drive that loads the ipxe.lkrn with Syslinux. Everything was fine until it tried to reach https://www.archlinux.org/releng/netboot/archlinux.ipxe . It hanged for a minute or two then I got the "Connection reset" message and it dropped me in the shell.
The network configuration is fine, DHCP works as it should, I got IP from my router, the netmask, gateway and DNS are okay, I can even load the demo on http://ipxe.org/
Only ifstat in the iPXE shell tells me that something's not right but at this point I'm lost, the error codes I got are not helpful to me.

iPXE> ifstat
net0: 00:25:21:ed:4e:be using rtl8161 on 0000:03:00.0 (open)
	[Link:up, TX:40 TXE:0 RX:94 RXE:61]
	[RXE: 59 x "The socket is not connected (http://ipxe.org/380f6001)"]
	[RXE: 1 x "Error 0x440e6003 (http://ipxe.org/440e6003)"]
	[RXE: 1 x "Connection reset (http://ipxe.org/0f0a6039)"]

Note: I have an AsRock P67 Pro3 motherboard and the USB drive I'm using loads Arch just fine in VirtualBox.

Last edited by freyr (2017-05-12 16:04:44)


What, so everyone's supposed to sleep every single night now? You realize that nighttime makes up half of all time?

Offline

Board footer

Powered by FluxBB