Network fails after upgrade

bwicksall · 2017-12-07 18:18:16

So today I ran pacman -Syu and rebooted. During boot I saw a message "Failed to start A basic static ethernet connection". Once into KDE I had no network. Not even a link light.

I have a simple static config with netctl. My hardware is a Dell Precision T3610 with onboard Intel network adapter.

I had to get back up and running so I downgraded my kernel:

sudo pacman -U linux-4.13.7-1-x86_64.pkg.tar.xz nvidia-387.12-2-x86_64.pkg.tar.xz nvidia-utils-387.12-1-x86_64.pkg.tar.xz nvidia-settings-387.12-1-x86_64.pkg.tar.xz virtualbox-host-modules-arch-5.1.30-1-x86_64.pkg.tar.xz

Any ideas how i should proceed? I'm up and running now but I'm apprehensive about my next upgrade.

jasonwryan · 2017-12-07 19:35:51

Find out why the network is failing: read you journal.

bwicksall · 2017-12-07 21:13:50

I don't see anything that stands out. Just a connection timeout.

Dec 07 12:05:19 bob-arch-05 kernel: e1000e: Intel(R) PRO/1000 Network Driver - 3.2.6-k
Dec 07 12:05:19 bob-arch-05 kernel: e1000e: Copyright(c) 1999 - 2015 Intel Corporation.
Dec 07 12:05:19 bob-arch-05 kernel: e1000e 0000:00:19.0: Interrupt Throttling Rate (ints/sec) set to dynamic conservative mode
Dec 07 12:05:19 bob-arch-05 kernel: i8042: PNP: No PS/2 controller found.
Dec 07 12:05:19 bob-arch-05 kernel: i8042: PNP: No PS/2 controller found.
Dec 07 12:05:19 bob-arch-05 kernel: e1000e 0000:00:19.0 0000:00:19.0 (uninitialized): registered PHC clock
Dec 07 12:05:19 bob-arch-05 kernel: i8042: PNP: No PS/2 controller found.
Dec 07 12:05:19 bob-arch-05 kernel: iTCO_vendor_support: vendor-support=0
Dec 07 12:05:19 bob-arch-05 kernel: i8042: PNP: No PS/2 controller found.
Dec 07 12:05:19 bob-arch-05 kernel: iTCO_wdt: Intel TCO WatchDog Timer Driver v1.11
Dec 07 12:05:19 bob-arch-05 kernel: iTCO_wdt: Found a Patsburg TCO device (Version=2, TCOBASE=0x0460)
Dec 07 12:05:19 bob-arch-05 kernel: iTCO_wdt: initialized. heartbeat=30 sec (nowayout=0)
Dec 07 12:05:19 bob-arch-05 kernel: e1000e 0000:00:19.0 eth0: (PCI Express:2.5GT/s:Width x1) 34:17:eb:bc:61:e5
Dec 07 12:05:19 bob-arch-05 kernel: e1000e 0000:00:19.0 eth0: Intel(R) PRO/1000 Network Connection
Dec 07 12:05:19 bob-arch-05 kernel: e1000e 0000:00:19.0 eth0: MAC: 10, PHY: 11, PBA No: 5041FF-0FF
Dec 07 12:05:19 bob-arch-05 kernel: e1000e 0000:00:19.0 enp0s25: renamed from eth0

<snip>

Dec 07 12:05:22 bob-arch-05 network[444]: Starting network profile 'ethernet-static'...
Dec 07 12:05:22 bob-arch-05 kernel: IPv6: ADDRCONF(NETDEV_UP): enp0s25: link is not ready
Dec 07 12:05:27 bob-arch-05 network[444]: No connection found on interface 'enp0s25' (timeout)
Dec 07 12:05:28 bob-arch-05 network[444]: Failed to bring the network up for profile 'ethernet-static'
Dec 07 12:05:28 bob-arch-05 systemd[1]: netctl@ethernet\x2dstatic.service: Main process exited, code=exited, status=1/FAILURE
Dec 07 12:05:28 bob-arch-05 kernel: e1000e: enp0s25 NIC Link is Down
Dec 07 12:05:28 bob-arch-05 systemd[1]: netctl@ethernet\x2dstatic.service: Failed with result 'exit-code'.
Dec 07 12:05:28 bob-arch-05 systemd[1]: Failed to start A basic static ethernet connection.

jasonwryan · 2017-12-07 21:27:43

Please use code tags when pasting to the boards: https://wiki.archlinux.org/index.php/Co … s_and_code

Connect manually, that will provide more useful debugging messages (make sure you stop/disable all networking service first).

loqs · 2017-12-07 21:42:23

https://bugs.archlinux.org/task/56575

bwicksall · 2017-12-08 02:04:55

That looks like my issue. Glad I'm not alone. Thanks!

Arch Linux

#1 2017-12-07 18:18:16

Network fails after upgrade

#2 2017-12-07 19:35:51

Re: Network fails after upgrade

#3 2017-12-07 21:13:50

Re: Network fails after upgrade

#4 2017-12-07 21:27:43

Re: Network fails after upgrade

#5 2017-12-07 21:42:23

Re: Network fails after upgrade

#6 2017-12-08 02:04:55

Re: Network fails after upgrade

Board footer