You are not logged in.

#1 2018-04-16 20:04:50

Elnee
Member
Registered: 2018-04-16
Posts: 18

[SOLVED] EFI System Partition doesn't shown

I want to boot Arch using systemd-boot.
If I got it right, I need mount my EFI System Partition to /mnt/boot.
But when I type "fdisk -l" or "gdisk -l /dev/sda" I haven't any partition with name contains "EFI".
But "efivar -l" shows all variables.
I want setup dual boot with Windows 10 pre-installed

Last edited by Elnee (2018-04-18 05:41:20)

Offline

#2 2018-04-16 20:13:46

WorMzy
Administrator
From: Scotland
Registered: 2010-06-16
Posts: 13,718
Website

Re: [SOLVED] EFI System Partition doesn't shown

Welcome to the forums, Elnee. Unfortunately your post doesn't contain any useful information which would help the community help you with your problem. Please, at the very least, post the output of the aforementioned commands. Use a pastebin service if you need to upload the output somewhere.

Please also share with us details of your hardware.

Mod note: Moving to NC.


Sakura:-
Mobo: MSI MAG X570S TORPEDO MAX // Processor: AMD Ryzen 9 5950X @4.9GHz // GFX: AMD Radeon RX 5700 XT // RAM: 32GB (4x 8GB) Corsair DDR4 (@ 3000MHz) // Storage: 1x 3TB HDD, 6x 1TB SSD, 2x 120GB SSD, 1x 275GB M2 SSD

Making lemonade from lemons since 2015.

Offline

#3 2018-04-17 18:10:34

Elnee
Member
Registered: 2018-04-16
Posts: 18

Re: [SOLVED] EFI System Partition doesn't shown

I'm sorry that I didn't do it right away.
gdisk -l /dev/sda
https://ptpb.pw/z_ng

fdisk -l /dev/sda
https://ptpb.pw/lKJz

efivar -l
https://ptpb.pw/QbXB

Hardware:
ASUS X556U (laptop)
Intel Core i5-7200U
8Gb RAM, 1Tb HDD
nVidia GeForce 940MX

Offline

#4 2018-04-17 18:14:36

Head_on_a_Stick
Member
From: The Wirral
Registered: 2014-02-20
Posts: 9,003
Website

Re: [SOLVED] EFI System Partition doesn't shown

Elnee wrote:

gdisk -l /dev/sda
https://ptpb.pw/z_ng

The Windows system was installed in non-UEFI mode and you have an msdos ("MBR" type) partition table on your hard drive.

I would recommend installing Arch in non-UEFI mode (see the wiki for details) but it may be possible to add an EFI system partition (using fdisk or parted) and boot Arch in UEFI mode, the firmware could then be used to toggle the operating systems.


Jin, Jîyan, Azadî

Offline

#5 2018-04-18 05:37:53

Elnee
Member
Registered: 2018-04-16
Posts: 18

Re: [SOLVED] EFI System Partition doesn't shown

Thanks you all. Now I know what to do.

Offline

Board footer

Powered by FluxBB