Arch Linux

Paramite

Member

From: Germany

Registered: 2018-04-22

Posts: 7

Wake On Lan only works when computer is turned off

I can turn on my computer with WOL, but I can't wake it up when Arch suspended my computer. Did I do something wrong?

Output of sudo ethtool enp2s0

Settings for enp2s0:
        Supported ports: [ TP MII ]
        Supported link modes:   10baseT/Half 10baseT/Full 
                                100baseT/Half 100baseT/Full 
                                1000baseT/Half 1000baseT/Full 
        Supported pause frame use: No
        Supports auto-negotiation: Yes
        Supported FEC modes: Not reported
        Advertised link modes:  10baseT/Half 10baseT/Full 
                                100baseT/Half 100baseT/Full 
                                1000baseT/Half 1000baseT/Full 
        Advertised pause frame use: Symmetric Receive-only
        Advertised auto-negotiation: Yes
        Advertised FEC modes: Not reported
        Link partner advertised link modes:  10baseT/Half 10baseT/Full 
                                             100baseT/Half 100baseT/Full 
        Link partner advertised pause frame use: Symmetric
        Link partner advertised auto-negotiation: Yes
        Link partner advertised FEC modes: Not reported
        Speed: 100Mb/s
        Duplex: Full
        Port: MII
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
        Supports Wake-on: pumbg
        Wake-on: g
        Current message level: 0x00000033 (51)
                               drv probe ifdown ifup
        Link detected: yes

Output of ifconfig enp2s0:

enp2s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.0.106  netmask 255.255.255.0  broadcast 192.168.0.255
        inet6 fe80::7717:98ea:5973:8524  prefixlen 64  scopeid 0x20<link>
        ether 01:23:45:67:89:ab:cd  txqueuelen 1000  (Ethernet)
        RX packets 2552  bytes 471950 (460.8 KiB)
        RX errors 0  dropped 26  overruns 0  frame 0
        TX packets 1309  bytes 188945 (184.5 KiB)
        TX errors 4  dropped 0 overruns 0  carrier 0  collisions 0

My LAN Card is TP-Link TG-3468.

I tried port 7 and port 9.

seth

Member

Registered: 2012-09-03

Posts: 51,282

Re: Wake On Lan only works when computer is turned off

Do you use some power saving tools (TLP, laptop-mode-tools,…) or do you have a parallel windows installation?

---

How to upload text · How to boot w/o GUI · Disable Windows Fast-Start! · Fix your xinitrc

Paramite

Member

From: Germany

Registered: 2018-04-22

Posts: 7

Re: Wake On Lan only works when computer is turned off

Thanks for your reply.
I don't use any power saving methods.
The only parallel installation I have is Solus.