Arch Linux

eparis

Member

From: NC, USA

Registered: 2015-08-20

Posts: 9

[SOLVED] Seahorse exits immediately

I need to edit a password in the Gnome keyring so I am trying to use Seahorse for that. However, Seahorse exits immediately right after I run it. Any ideas what could be causing this?

Thanks in advance!

Last edited by eparis (2018-09-12 17:49:46)

eparis

Member

From: NC, USA

Registered: 2015-08-20

Posts: 9

Re: [SOLVED] Seahorse exits immediately

I just found out that this was caused by the upgrade of Seahorse from 3.20.0+288+gce2340dc-1 -> 3.29.92+6+gdd81db31-1. Downgrading to the 3.20 version makes it work again. Hopefully this will all work once the migration to Gnome 3.30 is completed.