You are not logged in.

#1 2006-08-26 22:57:12

filoktetes
Member
From: Skien, Norway
Registered: 2003-12-29
Posts: 287

Anjuta doesn't work with glade-3

I was programming happily on my small project earlier today, and then I decided to update my system. After that Anjuta complained that I didn't have glade-2 installed. I saw that glade-2 had been replaced with glade-3. Nice, I thought, and symlinked glade-3 to glade-2, and hoped it would work. It doesn't. Anjuta doesn't seem to communicate with glade-3 at all.

I'll just downgrade glade, of course, but I would think that a lot of people who use glade also use anjuta. At least I find it extremely helpful. After looking a around on the Anjuta site, I haven't found glame-3 even mentioned, so I suppose it'll take a while before it's supported.

Offline

#2 2006-08-26 23:07:55

Snowman
Developer/Forum Fellow
From: Montreal, Canada
Registered: 2004-08-20
Posts: 5,212

Re: Anjuta doesn't work with glade-3

Please submit a bug report about that. Meanwhile, you can try rebuilding anjuta against glade-3. It usually fix these kind of errors unless glade3 is very different from glade2.

Offline

Board footer

Powered by FluxBB