Arch Linux

ushills

Member

Registered: 2019-09-02

Posts: 2

Fuse not working

I have an AppImage that I can get to work by running.

sudo modprobe fuse

I have tried creating a fuse.conf under /etc/modprobe.d/ with fuse as the content but this does not work.

How can I make the modprobe fuse persistant for all users so that I can launch the AppImage.

I have fuse2  and fuse 3 installed, using up to date Arch 64 bit with XFCE.

Thanks.

WorMzy

Forum Moderator

From: Scotland

Registered: 2010-06-16

Posts: 11,846

Website

Re: Fuse not working

I think you're mixing up modprobe.d and modules-load.d. You should use the latter: https://wiki.archlinux.org/index.php/Ke … th_systemd

---

Sakura:-
Mobo: MSI MAG X570S TORPEDO MAX // Processor: AMD Ryzen 9 5950X @4.9GHz // GFX: AMD Radeon RX 5700 XT // RAM: 32GB (4x 8GB) Corsair DDR4 (@ 3000MHz) // Storage: 1x 3TB HDD, 6x 1TB SSD, 2x 120GB SSD, 1x 275GB M2 SSD

Making lemonade from lemons since 2015.

ushills

Member

Registered: 2019-09-02

Posts: 2

Re: Fuse not working

Thanks, that was just what I was looking for.

2ManyDogs

Forum Fellow

Registered: 2012-01-15

Posts: 4,645

Re: Fuse not working

Please remember to mark your thread [SOLVED] (edit the title of your first post).