You are not logged in.

#1 2019-12-03 20:16:37

cesar_esteban
Member
Registered: 2019-12-03
Posts: 3

Wifi no longer working after upgrading to 5.4.1.arch1-1

After upgrading to the most recent kernel, I can't connect to my wifi router and when I run wifi-menu I get:

Scanning for networks... Could not read interface wlo1 flags: No such device
Could not read interface wlo1 flags: No such device
Could not read interface wlo1 flags: No such device
WEXT: Could not set interface 'wlo1' UP
wlo1: Failed to initialize driver interface
failed
No networks found

Then if I downgrade my kernel (5.4.1.arch1-1 => 5.3.7.arch1-1) and reboot, everything goes back to working.

Is there something I need to do to allow this update to work with my wifi chip?

Thanks.

Last edited by cesar_esteban (2019-12-03 20:52:07)

Offline

#2 2019-12-03 21:11:32

dglt
Member
Registered: 2019-08-14
Posts: 82

Re: Wifi no longer working after upgrading to 5.4.1.arch1-1

cesar_esteban wrote:

Is there something I need to do to allow this update to work with my wifi chip?

which is what make/model wifi adapter? logs?

Offline

#3 2019-12-03 21:33:53

cesar_esteban
Member
Registered: 2019-12-03
Posts: 3

Re: Wifi no longer working after upgrading to 5.4.1.arch1-1

Output of lspci

Network controller: Intel Corporation Wireless-AC 9560 [Jefferson Peak] (rev 10)

I'm not really sure what logs I should check. I'd have to upgrade again, check the logs then downgrade again and post the results. I can do that but it seems odd that this update would break this while previous ones didn't. I was hoping that someone knew why upgrading the kernel would cause this and how to fix it. The off the top of my head guess is that it has something to do with the firmware but am not sure. Thanks.

Offline

#4 2019-12-03 21:44:01

jasonwryan
Anarchist
From: .nz
Registered: 2009-05-09
Posts: 30,424
Website

Re: Wifi no longer working after upgrading to 5.4.1.arch1-1

You can read the journal from previous boots. See the wiki for filtering journalctl.


Arch + dwm   •   Mercurial repos  •   Surfraw

Registered Linux User #482438

Offline

#5 2019-12-03 22:07:50

cesar_esteban
Member
Registered: 2019-12-03
Posts: 3

Re: Wifi no longer working after upgrading to 5.4.1.arch1-1

From running journalctl -xe:

Dec 03 14:58:11 SMAUG kernel: CPU: 5 PID: 5731 Comm: wpa_supplicant Not tainted 5.4.1-arch1-1 #1
Dec 03 14:58:11 SMAUG kernel: Hardware name: Micro-Star International Co., Ltd. GF63 8RC/MS-16R1, BIOS E16R1IMS.108 09/13/2018
Dec 03 14:58:11 SMAUG kernel: Call Trace:
Dec 03 14:58:11 SMAUG kernel:  dump_stack+0x66/0x90
Dec 03 14:58:11 SMAUG kernel:  iwl_trans_pcie_send_hcmd+0x45d/0x470 [iwlwifi]
Dec 03 14:58:11 SMAUG kernel:  ? wait_woken+0x70/0x70
Dec 03 14:58:11 SMAUG kernel:  iwl_trans_send_cmd+0x51/0xb0 [iwlwifi]
Dec 03 14:58:11 SMAUG kernel:  iwl_mvm_send_cmd+0x1b/0x40 [iwlmvm]
Dec 03 14:58:11 SMAUG kernel:  iwl_mvm_legacy_config_scan+0x28e/0x450 [iwlmvm]
Dec 03 14:58:11 SMAUG kernel:  iwl_mvm_config_scan+0x11a/0x130 [iwlmvm]
Dec 03 14:58:11 SMAUG kernel:  iwl_mvm_up+0x8fb/0xc00 [iwlmvm]
Dec 03 14:58:11 SMAUG kernel:  __iwl_mvm_mac_start+0x26/0x1c0 [iwlmvm]
Dec 03 14:58:11 SMAUG kernel:  iwl_mvm_mac_start+0x24/0x40 [iwlmvm]
Dec 03 14:58:11 SMAUG kernel:  drv_start+0x3e/0x130 [mac80211]
Dec 03 14:58:11 SMAUG kernel:  ieee80211_do_open+0x20b/0x850 [mac80211]
Dec 03 14:58:11 SMAUG kernel:  ? ieee80211_check_concurrent_iface+0x14f/0x1c0 [mac80211]
Dec 03 14:58:11 SMAUG kernel:  __dev_open+0xe0/0x170
Dec 03 14:58:11 SMAUG kernel:  __dev_change_flags+0x18e/0x1f0
Dec 03 14:58:11 SMAUG kernel:  dev_change_flags+0x21/0x60
Dec 03 14:58:11 SMAUG kernel:  devinet_ioctl+0x5ed/0x730
Dec 03 14:58:11 SMAUG kernel:  inet_ioctl+0x1de/0x210
Dec 03 14:58:11 SMAUG kernel:  sock_do_ioctl+0x8b/0x190
Dec 03 14:58:11 SMAUG kernel:  sock_ioctl+0x281/0x3f0
Dec 03 14:58:11 SMAUG kernel:  do_vfs_ioctl+0x43d/0x6c0
Dec 03 14:58:11 SMAUG kernel:  ? syscall_trace_enter+0x19c/0x2e0
Dec 03 14:58:11 SMAUG kernel:  ksys_ioctl+0x5e/0x90
Dec 03 14:58:11 SMAUG kernel:  __x64_sys_ioctl+0x16/0x20
Dec 03 14:58:11 SMAUG kernel:  do_syscall_64+0x4e/0x140
Dec 03 14:58:11 SMAUG kernel:  entry_SYSCALL_64_after_hwframe+0x44/0xa9
Dec 03 14:58:11 SMAUG kernel: RIP: 0033:0x7f1774cbc25b
Dec 03 14:58:11 SMAUG kernel: Code: 0f 1e fa 48 8b 05 25 9c 0c 00 64 c7 00 26 00 00 00 48 c7 c0 ff ff ff ff c3 66 0f 1f 44 00 00 f3 0f 1e fa b8 10 00 00 >
Dec 03 14:58:11 SMAUG kernel: RSP: 002b:00007fff7dd09ef8 EFLAGS: 00000246 ORIG_RAX: 0000000000000010
Dec 03 14:58:11 SMAUG kernel: RAX: ffffffffffffffda RBX: 0000000000000001 RCX: 00007f1774cbc25b
Dec 03 14:58:11 SMAUG kernel: RDX: 00007fff7dd09f00 RSI: 0000000000008914 RDI: 0000000000000006
Dec 03 14:58:11 SMAUG kernel: RBP: 0000000000000006 R08: 00005651745bd016 R09: 0000000000000007
Dec 03 14:58:11 SMAUG kernel: R10: 0000000000000030 R11: 0000000000000246 R12: 0000000000000000
Dec 03 14:58:11 SMAUG kernel: R13: 00005651745c2af0 R14: 00007fff7dd09f00 R15: 0000000000000000
Dec 03 14:58:11 SMAUG kernel: iwlwifi 0000:00:14.3: Firmware not running - cannot dump error
Dec 03 14:58:11 SMAUG kernel: iwlwifi 0000:00:14.3: Applying debug destination EXTERNAL_DRAM
Dec 03 14:58:11 SMAUG netctl-auto[5720]: Could not set interface wlo1 flags (UP): Input/output error
Dec 03 14:58:11 SMAUG netctl-auto[5720]: nl80211: Could not set interface 'wlo1' UP

Offline

#6 2019-12-03 22:24:25

loqs
Member
Registered: 2014-03-06
Posts: 17,372

Re: Wifi no longer working after upgrading to 5.4.1.arch1-1

Offline

Board footer

Powered by FluxBB