You are not logged in.
- Topics: Active | Unanswered
#1 2019-12-26 17:04:51
- chaoxys
- Member
- From: Belgium
- Registered: 2019-12-26
- Posts: 2
[Solved] Bring eth interface up automatically
Hi,
I'm new on ArchLinux.
I would like to automatically bring up my enp0s3 ethernet interface.
I installed NetworkManager package.
My network connection is working, but after each reboot, I have to type the command "ip link set enp0s3 up".
I already set autoconnect yes with nmcli.
What could I do ?
Thanks a lot.
Last edited by chaoxys (2019-12-27 13:29:06)
Offline
#2 2019-12-26 21:57:33
- teckk
- Member
- Registered: 2013-02-21
- Posts: 525
Re: [Solved] Bring eth interface up automatically
Offline
#3 2019-12-26 23:03:50
- 2ManyDogs
- Forum Fellow
- Registered: 2012-01-15
- Posts: 4,645
Re: [Solved] Bring eth interface up automatically
Moving to Newbie Corner.
Offline
#4 2019-12-27 13:25:45
- chaoxys
- Member
- From: Belgium
- Registered: 2019-12-26
- Posts: 2
Re: [Solved] Bring eth interface up automatically
It seems to work with "nmcli dev connect enp03s".
Thanks.
Offline
#5 2019-12-27 14:13:28
- loqs
- Member
- Registered: 2014-03-06
- Posts: 18,124
Re: [Solved] Bring eth interface up automatically
The network connection is not established automatically on boot without any user interaction?
Offline
#6 2019-12-27 19:22:15
- archimboldo
- Member
- Registered: 2016-03-07
- Posts: 232
Re: [Solved] Bring eth interface up automatically
If i may add ...using dhcpcd is the easiest for a newbie.
https://wiki.archlinux.org/index.php/Dhcpcd#Running
Rules for problems.
Everyone has problems. Animals have problems. And buildings. And cats, and trees.
Problems are your friends. Treat them well.
Offline