You are not logged in.

#1 2020-02-15 08:41:13

pol4bear
Member
Registered: 2020-02-15
Posts: 11

[Solved] iwlwifi: Failed to start INIT ucode: -110 in kernel 5.5.3

I'm new to Arch Linux. I installed it on my laptop(LG Gram)
it seem fine post installation. I don't remember my wlan works post installation because I used wired. But, when I turned on my laptop today wlan interface load fails. I lastly installed wine 5.1 yesterday but I don't think is the reason. I searched other cases in google but I couldn't find any valid solutions. How can I fix my driver?

❯ lspci -kvnn | sed -n '/Network/,/^$/ p'
00:14.3 Network controller [0280]: Intel Corporation Cannon Point-LP CNVi [Wireless-AC] [8086:9df0] (rev 30)
        Subsystem: Intel Corporation Cannon Point-LP CNVi [Wireless-AC] [8086:0034]
        Flags: bus master, fast devsel, latency 0, IRQ 16
        Memory at a2618000 (64-bit, non-prefetchable) [size=16K]
        Capabilities: <access denied>
        Kernel driver in use: iwlwifi
        Kernel modules: iwlwifi
❯ dmesg | grep iwlwifi
[    2.746905] iwlwifi 0000:00:14.3: enabling device (0000 -> 0002)
[    2.756780] iwlwifi 0000:00:14.3: Found debug destination: EXTERNAL_DRAM
[    2.756783] iwlwifi 0000:00:14.3: Found debug configuration: 0
[    2.757082] iwlwifi 0000:00:14.3: loaded firmware version 46.ceaaecdc.0 op_mode iwlmvm
[    3.053411] iwlwifi 0000:00:14.3: Detected Intel(R) Dual Band Wireless AC 9560, REV=0x318
[    3.060880] iwlwifi 0000:00:14.3: Applying debug destination EXTERNAL_DRAM
[    3.061363] iwlwifi 0000:00:14.3: Allocated 0x00400000 bytes for firmware monitor.
[    8.178291] iwlwifi 0000:00:14.3: Failed to load firmware chunk!
[    8.178298] iwlwifi 0000:00:14.3: iwlwifi transaction failed, dumping registers
[    8.178301] iwlwifi 0000:00:14.3: iwlwifi device config registers:
[    8.178445] iwlwifi 0000:00:14.3: 00000000: 9df08086 00100406 02800030 00800000 a2618004 00000000 00000000 00000000
[    8.178450] iwlwifi 0000:00:14.3: 00000020: 00000000 00000000 00000000 00348086 00000000 000000c8 00000000 000001ff
[    8.178453] iwlwifi 0000:00:14.3: 00000040: 00928010 10000ec0 00100c10 00000000 00000000 00000000 00000000 00000000
[    8.178457] iwlwifi 0000:00:14.3: 00000060: 00000000 00080812 00000405 00000000 00000000 00000000 00000000 00000000
[    8.178461] iwlwifi 0000:00:14.3: 00000080: 800f0011 00002000 00003000 00000000 00000000 00000000 00000000 00000000
[    8.178465] iwlwifi 0000:00:14.3: 000000a0: 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000
[    8.178469] iwlwifi 0000:00:14.3: 000000c0: 00000000 00000000 c823d001 0d000008 00804005 00000000 00000000 00000000
[    8.178472] iwlwifi 0000:00:14.3: 000000e0: 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000
[    8.178476] iwlwifi 0000:00:14.3: 00000100: 14c00000 ff000000 000000ff 00462031 00000000 00002000 00000000 00000000
[    8.178479] iwlwifi 0000:00:14.3: 00000120: 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000
[    8.178483] iwlwifi 0000:00:14.3: 00000140: 00000000 00000000 00000000 16410018 00000000 0001001e 00481e1f 00000000
[    8.178486] iwlwifi 0000:00:14.3: iwlwifi device memory mapped registers:
[    8.178510] iwlwifi 0000:00:14.3: 00000000: 18c89008 00000040 00000000 00000000 00000000 00000000 00000000 00000000
[    8.178514] iwlwifi 0000:00:14.3: 00000020: 00000010 0c000005 00000312 d55555d5 d55555d5 d55555d5 80008040 001f0042
[    8.178523] iwlwifi 0000:00:14.3: Could not load the [0] uCode section
[    8.178535] iwlwifi 0000:00:14.3: Failed to start INIT ucode: -110
[    8.178540] iwlwifi 0000:00:14.3: Collecting data: trigger 16 fired.
[    8.428342] iwlwifi 0000:00:14.3: Not valid error log pointer 0x00000000 for Init uCode
[    8.428350] iwlwifi 0000:00:14.3: Fseq Registers:
[    8.428352] iwlwifi 0000:00:14.3: 0x6EFC0A0E | FSEQ_ERROR_CODE
[    8.428354] iwlwifi 0000:00:14.3: 0x00000000 | FSEQ_TOP_INIT_VERSION
[    8.428356] iwlwifi 0000:00:14.3: 0x7DC9CAA6 | FSEQ_CNVIO_INIT_VERSION
[    8.428358] iwlwifi 0000:00:14.3: 0x0000A384 | FSEQ_OTP_VERSION
[    8.428360] iwlwifi 0000:00:14.3: 0xA51C1518 | FSEQ_TOP_CONTENT_VERSION
[    8.428362] iwlwifi 0000:00:14.3: 0xC08AE419 | FSEQ_ALIVE_TOKEN
[    8.428364] iwlwifi 0000:00:14.3: 0xF6FC466C | FSEQ_CNVI_ID
[    8.428365] iwlwifi 0000:00:14.3: 0xB1E04F68 | FSEQ_CNVR_ID
[    8.428367] iwlwifi 0000:00:14.3: 0x01000100 | CNVI_AUX_MISC_CHIP
[    8.428371] iwlwifi 0000:00:14.3: 0x01300202 | CNVR_AUX_MISC_CHIP
[    8.428376] iwlwifi 0000:00:14.3: 0x0000485B | CNVR_SCU_SD_REGS_SD_REG_DIG_DCDC_VTRIM
[    8.428410] iwlwifi 0000:00:14.3: 0xA5A5A5A2 | CNVR_SCU_SD_REGS_SD_REG_ACTIVE_VDIG_MIRROR
[    8.428413] iwlwifi 0000:00:14.3: Firmware not running - cannot dump error
[    8.428582] iwlwifi 0000:00:14.3: Master Disable Timed Out, 100 usec
[    8.441398] iwlwifi 0000:00:14.3: Failed to run INIT ucode: -110

I found someone similar issue with me but his solution is not working for me.
I added GRUB_CMDLINE_LINUX_DEFAULT="loglevel=3 quiet intel_iommu=off" and grub-mkconfig again but it didn't work.

Last edited by pol4bear (2020-02-15 11:21:54)

Offline

#2 2020-02-15 11:20:50

pol4bear
Member
Registered: 2020-02-15
Posts: 11

Re: [Solved] iwlwifi: Failed to start INIT ucode: -110 in kernel 5.5.3

I'm not sure what is going on but it fixed after few reboot. I really to find solution and tried everything I found. It seem not worked at all. I found driver for my wlan and put in to /lib/firmware and rebooted. Now it works. After installing arch linux my wlan worked well but maybe something went wrong when installing softwares. Cheers

Offline

#3 2020-10-08 12:38:26

sho
Member
Registered: 2018-09-28
Posts: 2

Re: [Solved] iwlwifi: Failed to start INIT ucode: -110 in kernel 5.5.3

Hello, I've exactly the same problem with the same network controller since yesterday.
I also boot on GRUB and tried `intel_iommu=off` without success.

Which firmware do you use ?

Thanks

Offline

#4 2021-01-29 06:40:21

BradG
Member
Registered: 2021-01-29
Posts: 3

Re: [Solved] iwlwifi: Failed to start INIT ucode: -110 in kernel 5.5.3

I met it too, and  after a long time search on Archlinux, I guess it should be the problem with virtual device and PCI, so I tried to add some configuration at the virtualization drivers, virtio drivers ,vDPA drivers and VHost drivers ,you can try to add all the configurations , and then it works ,I can load firmware . remmeber don't add configuration of IOMMU Hardware suport.

Offline

#5 2021-01-29 06:40:57

BradG
Member
Registered: 2021-01-29
Posts: 3

Re: [Solved] iwlwifi: Failed to start INIT ucode: -110 in kernel 5.5.3

My kernel is 5.10.6 and updated from 4.9.10

Offline

#6 2021-02-07 07:03:40

spiritfall
Member
Registered: 2021-02-07
Posts: 1

Re: [Solved] iwlwifi: Failed to start INIT ucode: -110 in kernel 5.5.3

I'm having the same problem right now on linux-zen 5.10.13
I discovered that I get the same error in dmesg
Failed to start RT ucode: -110
Failed to run INIT ucode: -110

So it does not start at boot up. If I
rmmod iwlmvm iwlwifi mac80211 cfg80211
and then I reload iwlwifi, it works. But only if I do all of that manually.

UPDATE: problem was I was booting up with irqpoll parameter. Once I removed that, wifi started properly at boot.

Last edited by spiritfall (2021-02-07 10:37:14)

Offline

Board footer

Powered by FluxBB