You are not logged in.

#1 2020-03-23 18:38:41

korimitsu
Member
Registered: 2016-08-14
Posts: 21

Secure Boot support

Hi, is Secure Boot support a thing on Arch? For Windows 10, there's only difference to it if I have Bitlocker for the C: OS install, which is required otherwise I have to enter the recovery key each time I want to boot it. Otherwise I can have it either enabled or disabled.

When I want to install Arch from the iso can't with Secure Boot enabled, shows "Invalid signature detected".

Offline

#2 2020-03-23 18:46:21

Xyne
Moderator/TU
Registered: 2008-08-03
Posts: 6,481
Website

Re: Secure Boot support

Did you read our Secure Boot wiki article?


My Arch Linux StuffForum EtiquetteCommunity Ethos - Arch is not for everyone

Offline

#3 2020-03-23 20:15:06

korimitsu
Member
Registered: 2016-08-14
Posts: 21

Re: Secure Boot support

Xyne wrote:

Did you read our Secure Boot wiki article?

No I didn't. I though there was a quick answer.

Offline

#4 2020-03-23 20:39:20

progandy
Member
Registered: 2012-05-17
Posts: 3,722

Re: Secure Boot support

The quick answer is yes, but also no.
Yes, you can configure an installed arch linux to boot with secureboot.
No, the installation ISO cannot boot with secureboot enabled.

So disable secureboot until you have completed the installation and followed the wiki article.


| alias CUTF='LANG=en_XX.UTF-8@POSIX ' |

Offline

#5 2020-03-23 21:22:46

korimitsu
Member
Registered: 2016-08-14
Posts: 21

Re: Secure Boot support

Ok, so I can configure it later at any point after the install. Thanks for the info.

Offline

Board footer

Powered by FluxBB