You are not logged in.

#1 2020-11-20 11:46:24

lou
Member
Registered: 2020-11-20
Posts: 1

Logitech DiNovo - Keycodes

Hi,
as I need the USB-mode for dualboot, I don't want to run the Logitech DiNovo keyboard in bluetooth mode (where all keys are working).

As I can see on Windows and in this article (german) the multimediakeys are working in USB-mode.
But I can't get them working or get any signal with the tools named in the WIKI:
showkey --scancodes
and
evtest -> /dev/input/event6:      Logitech Logitech BT Mini-Receiver
are empty for the multimediakeys.

This output here is evertime the same. Doesn't matter if I pressed a key before:

journalctl --since "5 seconds ago"
-- Logs begin at Sun 2020-02-16 10:20:55 CET, end at Fri 2020-11-20 12:33:17 CET. --
Nov 20 12:33:13 hora kernel: usb 1-5.3: reset full-speed USB device number 6 using xhci_hcd
Nov 20 12:33:13 hora upowerd[866]: treating change event as add on /sys/devices/pci0000:00/0000:00:01.2/0000:20:00.0/0000:21:08.0/0000:2a:00.1/usb1/1-5/1-5.3
Nov 20 12:33:13 hora upowerd[866]: treating change event as add on /sys/devices/pci0000:00/0000:00:01.2/0000:20:00.0/0000:21:08.0/0000:2a:00.1/usb1/1-5/1-5.3
Nov 20 12:33:14 hora kernel: usb 1-5.3: reset full-speed USB device number 6 using xhci_hcd
Nov 20 12:33:14 hora upowerd[866]: treating change event as add on /sys/devices/pci0000:00/0000:00:01.2/0000:20:00.0/0000:21:08.0/0000:2a:00.1/usb1/1-5/1-5.3
Nov 20 12:33:14 hora upowerd[866]: treating change event as add on /sys/devices/pci0000:00/0000:00:01.2/0000:20:00.0/0000:21:08.0/0000:2a:00.1/usb1/1-5/1-5.3
Nov 20 12:33:16 hora kernel: usb 1-5.3: reset full-speed USB device number 6 using xhci_hcd
Nov 20 12:33:16 hora upowerd[866]: treating change event as add on /sys/devices/pci0000:00/0000:00:01.2/0000:20:00.0/0000:21:08.0/0000:2a:00.1/usb1/1-5/1-5.3
Nov 20 12:33:16 hora upowerd[866]: treating change event as add on /sys/devices/pci0000:00/0000:00:01.2/0000:20:00.0/0000:21:08.0/0000:2a:00.1/usb1/1-5/1-5.3
Nov 20 12:33:17 hora kernel: usb 1-5.3: reset full-speed USB device number 6 using xhci_hcd
Nov 20 12:33:17 hora upowerd[866]: treating change event as add on /sys/devices/pci0000:00/0000:00:01.2/0000:20:00.0/0000:21:08.0/0000:2a:00.1/usb1/1-5/1-5.3
Nov 20 12:33:17 hora upowerd[866]: treating change event as add on /sys/devices/pci0000:00/0000:00:01.2/0000:20:00.0/0000:21:08.0/0000:2a:00.1/usb1/1-5/1-5.3

Any ideas to get the keys running?

Thanks
Lou

Offline

Board footer

Powered by FluxBB