You are not logged in.
Pages: 1
I habe problem using my wlan card in my laptop. In fact it isn't even recognised.
lspci gives the following output:
00:00.0 Host bridge: Intel Corporation Mobile Memory Controller Hub (rev 03)
00:01.0 PCI bridge: Intel Corporation Mobile PCI Express Graphics Port (rev 03)
00:1b.0 Class 0403: Intel Corporation 82801G (ICH7 Family) High Definition Audio Controller (rev 02)
00:1c.0 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 1 (rev 02)
00:1c.1 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 2 (rev 02)
00:1c.2 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 3 (rev 02)
00:1c.3 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 4 (rev 02)
00:1d.0 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI #1 (rev 02)
00:1d.1 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI #2 (rev 02)
00:1d.2 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI #3 (rev 02)
00:1d.3 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI #4 (rev 02)
00:1d.7 USB Controller: Intel Corporation 82801G (ICH7 Family) USB2 EHCI Controller (rev 02)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev e2)
00:1f.0 ISA bridge: Intel Corporation 82801GBM (ICH7-M) LPC Interface Bridge (rev 02)
00:1f.1 IDE interface: Intel Corporation 82801G (ICH7 Family) IDE Controller (rev 02)
00:1f.3 SMBus: Intel Corporation 82801G (ICH7 Family) SMBus Controller (rev 02)
01:00.0 VGA compatible controller: nVidia Corporation Unknown device 01d8 (rev a1)
03:00.0 Network controller: Intel Corporation Unknown device 4222 (rev 02)
09:05.0 Ethernet controller: Broadcom Corporation BCM4401-B0 100Base-TX (rev 02)
09:09.0 CardBus bridge: Ricoh Co Ltd RL5c476 II (rev b4)
09:09.1 FireWire (IEEE 1394): Ricoh Co Ltd R5C552 IEEE 1394 Controller (rev 09)
09:09.2 Class 0805: Ricoh Co Ltd R5C822 SD/SDIO/MMC/MS/MSPro Host Adapter (rev 18)
09:09.3 System peripheral: Ricoh Co Ltd Unknown device 0843
09:09.4 System peripheral: Ricoh Co Ltd R5C592 Memory Stick Bus Host Adapter (rev 09)
09:09.5 System peripheral: Ricoh Co Ltd xD-Picture Card Controller (rev 04)
I think the highlighted line should be the wlan card.
Windows says, it's a Intel(R) Pro/Wireless 3945ABG Network Connection.
So I downloaded the ipw3945 stuff, loaded the module and tried to start the daemon. But the daemon fails to start. Error message: "No such file or directory".
Has anyone an idea?
Offline
Did you follow the instructions in the wiki ?
Wireless_Setup#ipw3945
Disliking systemd intensely, but not satisfied with alternatives so focusing on taming systemd.
clean chroot building not flexible enough ?
Try clean chroot manager by graysky
Offline
Yes, I followed the instructions in the wiki.
I installed those packages.
Added ipw3945 to modules() and ipw3945d to daemons().
iwconfig says:
lo no wireless extensions
eth0 no wireless extensions
eth1 no wireless extensions
I recently tried knoppix but it couldn't detect the card either.
Offline
please post the networking section of rc.conf and your /etc/conf.d/wireless file.
The brand and type of your laptop along with the output of
lsmod |grep ipw
might also help.
Disliking systemd intensely, but not satisfied with alternatives so focusing on taming systemd.
clean chroot building not flexible enough ?
Try clean chroot manager by graysky
Offline
Finally I managed to install the card.
I have a Core2Duo and am trying to use Arch64.
The ipw3945d package contains the i686 binary. So I downloaded the the right binary.
Where should I report the error?
Offline
Pages: 1