Arch Linux

exec00t

Member

Registered: 2022-07-28

Posts: 1

Restart Avermedia GC570

The Avermedia GC570 capture card is often disabled in standby mode and not only.
It doesn't turn on itself. Only after restarting xhci.

28.07.2022 10:10    usb 11-2    UVC non compliance - GET_DEF(PROBE) not supported. Enabling workaround.
28.07.2022 10:10    usb 11-2    UVC non compliance - GET_DEF(PROBE) not supported. Enabling workaround.
28.07.2022 10:10    usb 11-2    reset SuperSpeed USB device number 30 using xhci_hcd
28.07.2022 10:10    usb 11-2    USB disconnect, device number 30
28.07.2022 10:10    usb 11-2    new SuperSpeed USB device number 31 using xhci_hcd
28.07.2022 10:10    usb 11-2    New USB device found, idVendor=07ca, idProduct=0570, bcdDevice= 1.00
28.07.2022 10:10    usb 11-2    New USB device strings: Mfr=6, Product=7, SerialNumber=3
28.07.2022 10:10    usb 11-2    Product: AVerMedia USB Device
28.07.2022 10:10    usb 11-2    Manufacturer: AVerMedia
28.07.2022 10:10    usb 11-2    SerialNumber: 520219
28.07.2022 10:10    usb 11-2    Found UVC 1.00 device AVerMedia USB Device (07ca:0570)
28.07.2022 10:10    usb 11-2    UVC non compliance - GET_DEF(PROBE) not supported. Enabling workaround.
28.07.2022 10:10    usb 11-2    UVC non compliance - GET_DEF(PROBE) not supported. Enabling workaround.
28.07.2022 10:10    usb 11-2    timeout: still 6 active urbs on EP #8a
28.07.2022 10:10    xhci_hcd 0000    3:00.0: xHCI host not responding to stop endpoint command.
28.07.2022 10:10    xhci_hcd 0000    3:00.0: USBSTS: 0x00000000
28.07.2022 10:10    xhci_hcd 0000    3:00.0: xHCI host controller not responding, assume dead
28.07.2022 10:10    xhci_hcd 0000    3:00.0: HC died; cleaning up
28.07.2022 10:10    usb 11-2    USB disconnect, device number 31
28.07.2022 10:10    usb 11-2    Not enough bandwidth for altsetting 0
28.07.2022 10:10    usb 11-2    3:0: usb_set_interface failed (-19)

I think the problem is in the motherboard. GA-970A-UD3P
Is that true?

Last edited by exec00t (2022-07-28 07:22:09)