You are not logged in.
Pages: 1
i got slow eth on my arch around 100kb/s while i should have 500mb/s... im using networkmanager and have tried to use systemd-networkd both work at slow speed...i dunno what to do since i got a 2gb patch im trying to reduce for just a kernel update which still big since its 300mb...btw i use to have normal eth speeds on arch.. hope it will fix but almost sure it wont... what u guys suggest?
Last edited by jony (2022-09-01 23:53:46)
Offline
What is the NIC? What kernel module is it using? What is the link speed as reported by ethtool? Has the issue always been present?
Last edited by loqs (2022-09-01 23:22:01)
Offline
00:1f.6 Ethernet controller: Intel Corporation Ethernet Connection (7) I219-V (rev 10)
DeviceName: Onboard - Ethernet
Subsystem: ASUSTeK Computer Inc. Device 8672
Flags: bus master, fast devsel, latency 0, IRQ 139
Memory at a4300000 (32-bit, non-prefetchable) [size=128K]
Capabilities: <access denied>
Kernel driver in use: e1000e
Kernel modules: e1000e
[ 2.329660] e1000e: Intel(R) PRO/1000 Network Driver
[ 2.329661] e1000e: Copyright(c) 1999 - 2015 Intel Corporation.
[ 2.329839] e1000e 0000:00:1f.6: Interrupt Throttling Rate (ints/sec) set to dynamic conservative mode
[ 2.723248] e1000e 0000:00:1f.6 0000:00:1f.6 (uninitialized): registered PHC clock
[ 2.792904] e1000e 0000:00:1f.6 eth0: (PCI Express:2.5GT/s:Width x1) a8:5e:45:e6:ec:94
[ 2.792912] e1000e 0000:00:1f.6 eth0: Intel(R) PRO/1000 Network Connection
[ 2.792968] e1000e 0000:00:1f.6 eth0: MAC: 13, PHY: 12, PBA No: FFFFFF-0FF
[ 2.824560] e1000e 0000:00:1f.6 eno1: renamed from eth0
[ 5.875459] e1000e 0000:00:1f.6 eno1: NIC Link is Up 1000 Mbps Full Duplex, Flow Control: None
[ 351.030450] e1000e 0000:00:1f.6 eno1: NIC Link is Up 1000 Mbps Full Duplex, Flow Control: None
Speed: 1000Mb/s
Last edited by jony (2022-09-01 23:33:41)
Offline
ok find out the problem...im so dumb... old mirrors i just update them and its back to normal
Offline
Pages: 1