You are not logged in.
Pages: 1
Hi
I recently install arch for thousands times, but when I try to reboot after installation process, when the arch booting I see this:
a start job is running for file system check on /dev/disk/by-uid/*And boot process stoping...
I try fsck and see in the wiki in the fstab file I can use 0 for this partition doesn't check...
I don't try it, because I think if there is a problem that's better to solved, not deleted...
How can I do?
Thanks for your time
Last edited by SinaSSD (2023-03-31 16:47:46)
Offline
I don't try it, because I think if there is a problem
Is there a problem? What does fsck actually report?
Also make sure to remove the "quiet" parameter from the kernel commandline.
Did you try to switch to a different VT?
Offline
I don't try it, because I think if there is a problem
Is there a problem? What does fsck actually report?
Also make sure to remove the "quiet" parameter from the kernel commandline.
Did you try to switch to a different VT?
Thanks for your reply
I remove quite before, I have a shrdpart between arch and windows )vfat), I edit the fstab and write 0 instead of 4, now all the things are ok
But fsck do not shows me any error:
fsck -r /dev/sda14
2
/var.tgz
File size is 0 bytes, cluster chain length is > 0 bytes.
Truncating file to 0 bytes.
And stops there...
Last edited by SinaSSD (2023-03-31 19:32:11)
Offline
Post the output of "lsblk -f" and your complete system journal for the boot:
sudo journalctl -b | curl -F 'file=@-' 0x0.stOffline
Pages: 1