You are not logged in.
Hi there. I just finished changing my motherboard, and the only issue left now i can't solve myself and it's really weird - one of my network cards isn't being detected as an ethernet interface, but rather as a non-VGA misc. device or something to that effect =/ Running 2.6.19-beyond, motherboard in question is an Abit NF7-S 2.0. APIC disabled in BIOS.
Here's info:
Ifconfig
br0 Link encap:Ethernet HWaddr 00:50:8D:F1:DA:DE
inet addr:10.0.0.20 Bcast:10.0.0.255 Mask:255.255.255.0
inet6 addr: fe80::250:8dff:fef1:dade/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2030 errors:0 dropped:0 overruns:0 frame:0
TX packets:1983 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1708982 (1.6 Mb) TX bytes:361255 (352.7 Kb)eth0 Link encap:Ethernet HWaddr 00:50:8D:F1:DA:DE
inet6 addr: fe80::250:8dff:fef1:dade/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2030 errors:0 dropped:0 overruns:0 frame:0
TX packets:1977 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1738082 (1.6 Mb) TX bytes:361003 (352.5 Kb)
Interrupt:3 Base address:0x4000eth1 Link encap:UNSPEC HWaddr 00-00-00-50-8D-F0-DA-DE-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:28 errors:0 dropped:0 overruns:0 frame:0
TX packets:28 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1894 (1.8 Kb) TX bytes:1894 (1.8 Kb)
rc.conf
#
# /etc/rc.conf - Main Configuration for Arch Linux
##
# Localization
#
# HARDWARECLOCK: set to "UTC" or "localtime"
# TIMEZONE: timezones are found in /usr/share/zoneinfo
# KEYMAP: keymaps are found in /usr/share/kbd/keymaps
# CONSOLEFONT: fount in /usr/share/kbd/consolefonts (only needed for non-us)
# USECOLOR: use ANSI color sequences in startup messages
#
LOCALE="nb_NO.UTF-8"
HARDWARECLOCK="UTC"
TIMEZONE="Europe/Oslo"
KEYMAP="no-latin1"
CONSOLEFONT=
CONSOLEMAP=
USECOLOR="yes"# Scan for LVM volume groups at startup, required if you use LVM
USELVM="no"#
# Networking
#
HOSTNAME="jcberg"
MOD_AUTOLOAD="yes"
MOD_BLACKLIST=(agpgart via-agp nvidia usbserial ide-scsi eeprom pcspkr)
#
# Module to load at boot-up (in this order)
# (prefix a module with a ! to disable it)
#
MODULES=(!agpgart !via-agp !nvidia !usbserial 8139too forcedeth bridge !ide-scsi snd-seq snd-seq-oss cdrom ide-cd snd-intel8x0 usbcore usbhid usb-storage sd_mod evdev capability joydev)#
# Interfaces to start at boot-up (in this order)
# Declare each interface then list in INTERFACES
# (prefix an interface in INTERFACES with a ! to disable it)
#
# Note: to use DHCP, set your interface to be "dhcp" (eth0="dhcp")
#lo="lo 127.0.0.1 up"
br0="br0 10.0.0.20 broadcast 10.0.0.255 netmask 255.255.255.0 up"
#eth0="eth0 10.0.0.20 broadcast 10.0.0.255 netmask 255.255.255.0 up"
eth0="eth0 0.0.0.0 up"
#wlan0="wlan0 0.0.0.0 up"
eth1="eth1 0.0.0.0 up"
INTERFACES=(lo eth0 eth1 br0)
#INTERFACES=(lo eth0)#
# Routes to start at boot-up (in this order)
# Declare each route then list in ROUTES
# (prefix a route in ROUTES with a ! to disable it)
#
gateway="default gw 10.0.0.138"
ROUTES=(gateway)#
# Daemons to start at boot-up (in this order)
# (prefix a daemon with a ! to disable it)
#
DAEMONS=(syslog-ng !pcmcia network netfs crond portmap hal fam alsa wshaper @ntpdate lighttpd sshd @vsftpd postfix updateip kdm)# End of file
lspci -vvvvvvvvvvv
00:00.0 Host bridge: nVidia Corporation nForce2 AGP (different version?) (rev c1)
Subsystem: ABIT Computer Corp. Unknown device 1c00
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort>SERR- <PERR-
Latency: 0
Region 0: Memory at e0000000 (32-bit, prefetchable) [size=64M]
Capabilities: [40] AGP version 3.0
Status: RQ=32 Iso- ArqSz=2 Cal=0 SBA+ ITACoh- GART64- HTrans- 64bit- FW+ AGP3+ Rate=x8
Command: RQ=1 ArqSz=0 Cal=0 SBA+ AGP+ GART64- 64bit- FW- Rate=x8
Capabilities: [60] HyperTransport: Host or Secondary Interface
Command: WarmRst+ DblEnd-
Link Control: CFlE- CST- CFE- <LkFail- Init+ EOC- TXO- <CRCErr>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR-
Latency: 0
Capabilities: [48] HyperTransport: Slave or Primary Interface
Command: BaseUnitID=1 UnitCnt=15 MastHost- DefDir-
Link Control 0: CFlE- CST- CFE- <LkFail- Init+ EOC+ TXO- <CRCErr=0
Link Config 0: MLWI=8bit MLWO=8bit LWI=8bit LWO=8bit
Link Control 1: CFlE- CST- CFE- <LkFail- Init+ EOC- TXO+ <CRCErr>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort+ <SERR- <PERR>Reset- FastB2B-00:09.0 IDE interface: nVidia Corporation nForce2 IDE (rev a2) (prog-if 8a [Master SecP PriP])
Subsystem: ABIT Computer Corp. Unknown device 1c00
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort+ <SERR- <PERR>Reset- FastB2B-01:07.0 Non-VGA unclassified device: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
Subsystem: Realtek Semiconductor Co., Ltd. RT8139
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR>TAbort- <TAbort- <MAbort>SERR- <PERR-
Latency: 248 (1250ns min, 250ns max)
Interrupt: pin A routed to IRQ 11
Region 0: Memory at e4000000 (32-bit, non-prefetchable) [size=16M]
Region 1: Memory at d0000000 (32-bit, prefetchable) [size=256M]
[virtual] Expansion ROM at e5000000 [disabled] [size=128K]
Capabilities: [60] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [44] AGP version 3.0
Status: RQ=32 Iso- ArqSz=0 Cal=3 SBA+ ITACoh- GART64- HTrans- 64bit- FW+ AGP3+ Rate=x4,x8
Command: RQ=32 ArqSz=2 Cal=0 SBA+ AGP+ GART64- 64bit- FW- Rate=x8
/proc/interrupts (eth1 doesn't have an interrupt, wierd order)
CPU0
0: 1664734 XT-PIC-XT timer
1: 5562 XT-PIC-XT i8042
2: 0 XT-PIC-XT cascade
3: 168516 XT-PIC-XT eth0
5: 35975 XT-PIC-XT ohci_hcd:usb1, ohci_hcd:usb5
7: 2104 XT-PIC-XT ohci_hcd:usb3
8: 0 XT-PIC-XT rtc
9: 0 XT-PIC-XT acpi
10: 6 XT-PIC-XT ehci_hcd:usb4, ohci1394
11: 100002 XT-PIC-XT NVidia nForce2, nvidia
12: 4 XT-PIC-XT ohci_hcd:usb2, ehci_hcd:usb6
14: 13460 XT-PIC-XT ide0
15: 19653 XT-PIC-XT ide1
NMI: 820
LOC: 1664387
ERR: 25
MIS: 0
Does anyonw might know what's wrong?
Offline
"01:07.0 Non-VGA unclassified device: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)"
Just a quick look and this might be the problem. Maybe try 8139C or 8139 vs 8139t00 in your rc.conf and see if your system will then recognize it. I don't have the MB that you are referencing but that stood out to me. HTH
Scratch that!!! I see where you are loading this OK w/int 11.
Skeeter
Rule #1: There are NO RULES!
Offline
Physically removing the card actually fixes a whole lot of problems. Probably motherboard not liking card.
Offline