You are not logged in.

#1 2025-06-19 07:38:25

Prymoo
Member
Registered: 2015-04-28
Posts: 17

No sound via HDMI after resume from suspend: ELD info empty

Since updating to kernel 6.15, I no longer get sound via HDMI after resuming from suspend. The HDMI output shows as disconnected in pavucontrol. If I manually reselect the HDMI output device, the sound starts working again. This issue does not occur on linux-lts (6.12.31), where HDMI audio resumes normally.

My GPU is AMD RX 6600, using PipeWire with WirePlumber.

Here’s an excerpt from the WirePlumber log after resume:

cze 19 08:55:06 pdesktop wireplumber[2578]: D spa.alsa [alsa-util.c:1996:pa_alsa_get_hdmi_eld]: ELD info empty (for device=7)
cze 19 08:55:06 pdesktop wireplumber[2578]: I spa.alsa [alsa-acp-device.c:893:card_props_changed]: card properties changed
cze 19 08:55:06 pdesktop wireplumber[2578]: D spa.alsa [acp.c:760:report_jack_state]: Jack 'HDMI/DP,pcm=7 Jack' is now unplugged
cze 19 08:55:06 pdesktop wireplumber[2578]: I spa.alsa [alsa-acp-device.c:975:card_port_available]: card port hdmi-output-1 available yes -> no
cze 19 08:55:06 pdesktop wireplumber[2578]: I spa.alsa [acp.c:702:profile_set_available]: Profile output:hdmi-stereo-extra1 available yes -> no
cze 19 08:55:06 pdesktop wireplumber[2578]: I spa.alsa [alsa-acp-device.c:941:card_profile_available]: card profile output:hdmi-stereo-extra1 available yes -> no

Offline

Board footer

Powered by FluxBB