Arch Linux

Ihaveaquestion

Member

Registered: 2025-10-20

Posts: 1

Hyprlrand loads only in dGPU-only mode

Hi. I am a newbie trying to install Arch + Hyprland on an Asus Rog Zephyrus G16 (4070 + Ryzen AI 9 HX 370). I have both iGPU and dGPU. After installing asusctl, asus kernel etc. from arch setup guide from asus-linux, I managed to run Hyprland. However, the problem is it only works when I set the mode to dGPU only, otherwise it freezes during the load (without any meaningful log despite logs being enabled in the config.). I did set hyprland up according to the multi-GPU guide. I would like to use hyprland in hybrid mode. Does anyone know how to fix this problem?
PS. Apparently it works on an external monitor (I set my monitor in the hyprland config according to the wiki). Also the log at which hyprland stops loading is "Direct prop rule found rewritten nofocus -> prop nofocus"

Last edited by Ihaveaquestion (2025-10-20 20:09:35)

V1del

Forum Moderator

Registered: 2012-10-16

Posts: 24,923

Re: Hyprlrand loads only in dGPU-only mode

Post your config and the output of

sudo journalctl -b |  curl -F 'file=@-' 0x0.st

while in a "not working boot"