You are not logged in.

#1 Today 17:02:13

tttt
Member
Registered: 2026-02-05
Posts: 6

Failing to resume from suspend, suspect is my monitor setup

journalctl -b-1 output. When I resume from suspend sometimes I just get a black screen, my i3wm binds that run xrandr commands don't do anything, and switching to tty doesn't work either. I am pretty sure that this line:

Nov 17 08:35:08 tonybellabox kernel: nvidia-modeset: WARNING: GPU:0: Lost display notification (0:0x00000000); continuing.

is the most worrying error. The most recent change I made to my setup was adding an additional monitor. Here is xrandr output:

~ % xrandr
Screen 0: minimum 8 x 8, current 2560 x 1440, maximum 32767 x 32767
HDMI-0 disconnected (normal left inverted right x axis y axis)
DP-0 disconnected (normal left inverted right x axis y axis)
DP-1 disconnected (normal left inverted right x axis y axis)
DP-2 connected primary 2560x1440+0+0 (normal left inverted right x axis y axis) 590mm x 330mm
   2560x1440     59.95 + 540.00*  269.98   239.97   120.00
   1920x1080    539.99   240.00   119.88   100.00    60.00    59.94    50.00    29.97    25.00    23.98
   1600x1200     60.00
   1280x1024     60.02
   1280x960      60.00
   1280x720      60.00    59.94    50.00
   1024x768      75.03    60.00
   800x600       75.00    60.32
   720x576       50.00
   720x480       59.94
   640x480       75.00    59.94    59.93
DP-3 disconnected (normal left inverted right x axis y axis)
DP-4 connected (normal left inverted right x axis y axis)
   3840x1080     59.97 + 239.97   119.97
   5120x1440    239.76   120.00    59.98
   2560x1440    239.90   120.00    59.95
   2560x1080    119.88    60.00    59.94
   1920x1080    119.88    60.00    59.94
   1680x1050     59.95
   1600x900      60.00
   1440x900      59.89
   1280x1024     75.02    60.02
   1280x800      59.81
   1280x720      60.00
   1152x864      75.00
   1024x768      75.03    70.07    60.00
   800x600       75.00    72.19    60.32    56.25
   640x480       75.00    72.81    59.94
DP-5 disconnected (normal left inverted right x axis y axis)

I used to just have the Samsung G9 (the one connected to DP-4), but I added an Asus 540Hz OLED. I had 2 Samsung G9s at some point and was able to switch between them, but I've basically always had resume from suspend issues so I'm not entirely sure that was working either. I think resuming from suspend is a lot more reliable when I only have one monitor (I need to unplug the power or displayport cable, as just powering off the monitor still allows the PC and monitor to communicate apparently). An acceptable workaround would be some ability in software to disable communications between the PC and the monitor and some way of switching between my monitors that enables the other one and disables the current one.

Offline

#2 Today 18:11:43

tttt
Member
Registered: 2026-02-05
Posts: 6

Re: Failing to resume from suspend, suspect is my monitor setup

Huh, I just figured out that if I turn off the Samsung G9 xrandr output no longer shows it as connected, but my ASUS monitor even if I turn it off Linux still detects it... This feels somewhat like the ASUS monitor is misbehaving? It is a known issue that some monitors just refuse to actually turn off?

Offline

Board footer

Powered by FluxBB