You are not logged in.
Pages: 1
Prior to using the PATA hook, I could mount my usb stick using /dev/sda1 , the other disks being /dev/hda, b & c
Now, I'm confused, since despite reading other threads, I can't find any reference to my problem.
After connecting the stick, lsusb gives:
Bus 004 Device 001: ID 0000:0000
Bus 003 Device 001: ID 0000:0000
Bus 001 Device 004: ID 067b:2515 Prolific Technology, Inc. Flash Disk Embedded Hub
Bus 001 Device 005: ID 067b:2517 Prolific Technology, Inc. Flash Disk Mass Storage Device
Bus 001 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
dmesg |grep usb gives:
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
usb usb1: configuration #1 chosen from 1 choice
usb usb2: configuration #1 chosen from 1 choice
usb usb3: configuration #1 chosen from 1 choice
usb usb4: configuration #1 chosen from 1 choice
usb 1-2: new high speed USB device using ehci_hcd and address 2
usb 1-2: configuration #1 chosen from 1 choice
usb 1-2.1: new high speed USB device using ehci_hcd and address 3
usb 1-2.1: configuration #1 chosen from 1 choice
usb 1-2: USB disconnect, address 2
usb 1-2.1: USB disconnect, address 3
usb 1-2: new high speed USB device using ehci_hcd and address 4
usb 1-2: configuration #1 chosen from 1 choice
usb 1-2.1: new high speed USB device using ehci_hcd and address 5
usb 1-2.1: configuration #1 chosen from 1 choice
ls /dev/sd* gives
/dev/sda /dev/sda1 /dev/sdb /dev/sdb1 /dev/sdc /dev/sdc1 /dev/sdc2 /dev/sdc3 /dev/sdc4
and fdisk -l gives:
Disk /dev/sda: 3243 MB, 3243663360 bytes
128 heads, 63 sectors/track, 785 cylinders
Units = cylinders of 8064 * 512 = 4128768 bytes
Device Boot Start End Blocks Id System
/dev/sda1 * 1 784 3161056+ b W95 FAT32
Disk /dev/sdb: 160.0 GB, 160041885696 bytes
255 heads, 63 sectors/track, 19457 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/sdb1 * 1 19457 156288321 83 Linux
Disk /dev/sdc: 160.0 GB, 160041885696 bytes
255 heads, 63 sectors/track, 19457 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/sdc1 * 1 12 96358+ 83 Linux
/dev/sdc2 13 255 1951897+ 82 Linux swap / Solaris
/dev/sdc3 256 3051 22458870 83 Linux
/dev/sdc4 3052 19457 131781195 83 Linux
ie no reference to the connected flash stick.
The only clue is that ls /dev/usb* gives:
/dev/usbdev1.1_ep00 /dev/usbdev1.5_ep00 /dev/usbdev2.1_ep81 /dev/usbdev4.1_ep81
/dev/usbdev1.1_ep81 /dev/usbdev1.5_ep01 /dev/usbdev3.1_ep00
/dev/usbdev1.4_ep00 /dev/usbdev1.5_ep82 /dev/usbdev3.1_ep81
/dev/usbdev1.4_ep81 /dev/usbdev2.1_ep00 /dev/usbdev4.1_ep00
But mounting any of these to /mnt/xxx results in a request for specifying the filetype, which never happened previously as the partitions are ext2. Plus thats an awful lot of trial and error to try and mount!
Any ideas how to mount this 2 partition flash stick?
Offline
shouldnt it just be mount /dev/sda1 /mnt/xxx?
you can check dmesg to see what its assigning it to upon plug in
Offline
Oh well its working now after a reboot as /dev/sdd 1 & 2 (which is what I expected originally).
Weird.
Offline
Pages: 1