Arch Linux

keerthi

Member

Registered: 2007-11-18

Posts: 95

brasero: should I activate libburn backend?

(3/3) installing brasero                            [#####################] 100%
>> To enable libburn backend you need to activate it in GConf:
>> /apps/brasero/config/libburn_burn
>> /apps/brasero/config/libburn_iso

I get this message when installing brasero. I haven't done anything about libburn so far and brasero seems to work fine. What is it? Should I care about activating libburn is gconf?

Last edited by keerthi (2008-01-25 20:12:38)

slackhack

Member

Registered: 2004-06-30

Posts: 738

Re: brasero: should I activate libburn backend?

Have you tried burning ISOs yet? That might fail without activating libburn_iso. It's probably safer just to enable both of them.

Bestiapeluda

Member

From: Buenos Aires, Argentina

Registered: 2007-10-16

Posts: 181

Re: brasero: should I activate libburn backend?

Does brasero work without gnome ?

gothmog.todi

Member

From: Austria

Registered: 2007-07-18

Posts: 120

Re: brasero: should I activate libburn backend?

it does depend on gconf, totem and nautilus, if that's what you mean.
But there is no problem in using it in other de's/wm's

slackhack

Member

Registered: 2004-06-30

Posts: 738

Re: brasero: should I activate libburn backend?

I thought the ISO I burned failed, but I just tried it in another computer and it booted. so maybe libburn isn't necessary? The burn without it gave a failed error message, but the disc worked anyway. So now I"m not sure. I tend to say "if it's not broken, don't fix it."