You are not logged in.
I have just installed Arch on a dell d620 laptop. It is using the bcm43xx wireless driver.
I can connect to my AP automatically via the wireless.conf script. Everything works fine from the console.
When I start X, I am still connected to the AP, but I can no reach any network address, even local address on my 192.168.1.x network.
I then have to ifconfig eth1 down, ifconfig eth1 up, iwconfig eth1 essid "myapname". Then I have to set the route via route add default gw 192.168.1.1.
I only have to do this after starting X.
Does anyone have any ideas to help me out?
Offline
Drastic solution is to write those all commands into .xinitrc file so then you fire "startx" they all will be entered.
Offline