You are not logged in.
Hello,
I just got this very nice mouse and I have trouble to get it working. I am not a Linux newbie (not guru aether). Well to the point now, I have searched trough this Forum and Wiki and Google and all i have found is numerous ways to configure it for xorg, however, the problem is, that i can't get it to be detected by kernel:
cat /proc/bus/input/devices | grep Name
N: Name="Power Button (FF)"
N: Name="Lid Switch"
N: Name="Sleep Button (CM)"
N: Name="ThinkPad Extra Buttons"
N: Name="hdaps"
N: Name="AT Translated Set 2 keyboard"
N: Name="TPPS/2 IBM TrackPoint"
Currently i am using Archlinux with "Vanilla" kernel and have evdev module loaded at strtup:
# lsmod
Module Size Used by
michael_mic 2112 4
arc4 1600 4
ecb 2432 4
ieee80211_crypt_tkip 8192 2
usbhid 34084 0
evdev 7680 5
snd_intel8x0m 12108 0
snd_intel8x0 25372 2
snd_ac97_codec 87332 2 snd_intel8x0m,snd_intel8x0
snd_pcm_oss 31936 0
snd_pcm 56200 4 snd_intel8x0m,snd_intel8x0,snd_ac97_codec,snd_pcm_oss
snd_timer 16260 1 snd_pcm
snd_page_alloc 6792 3 snd_intel8x0m,snd_intel8x0,snd_pcm
snd_mixer_oss 11968 1 snd_pcm_oss
snd 38900 11 snd_intel8x0m,snd_intel8x0,snd_ac97_codec,snd_pcm_oss,snd_pcm,snd_timer,snd_mixer_oss
soundcore 5124 1 snd
ac97_bus 1408 1 snd_ac97_codec
ipw2200 121480 0
ieee80211 24712 1 ipw2200
ieee80211_crypt 4096 2 ieee80211_crypt_tkip,ieee80211
I do still have the original Arch kernel, but results with it is the same, so if someone of you nice people are using Logitech V220 or similar mouse, i would be gretefull if you would share your "lsmod".
Thank you verry much in advance.
Egidijus.
Last edited by Iketani (2008-08-23 21:13:37)
If music be the food of love, then play on!
Mick Fleetwood
Offline
Sorry for bringing this post up, but :bump:
Tried to recompile my kernel and added usbhid and usbmouse support altho i still can't see my mouse detected by kernel
Last edited by Iketani (2008-08-20 19:56:41)
If music be the food of love, then play on!
Mick Fleetwood
Offline
I'm certainly no expert, but do you have usbcore and uchi_hcd , I think you need them for usb mouse support, both are listed in my lsmod. I could totally be wrong though, I just followed the beginners wiki when I installed and my usb mouse (logitech wireless trackball) worked
Offline
Ok, affter i have done some research based on uchi_hcd, i found out that i forgot to enable uchi and echi support in usb section, affter i done that, my little mouse works perfect. Actually running lspci -v you can see what modules you need to have for your harware to work i thank people that replied, it really helped alot.
If music be the food of love, then play on!
Mick Fleetwood
Offline