Arch Linux

murderbymodem

Member

From: New Jersey

Registered: 2008-07-24

Posts: 41

Openbox crashes when I go to another VC and then switch back.

Okay, while running openbox I press CTRL + ALT + F2 to go to vc/2, then I go back to the vc/1 where openbox was, and I get the following:

(obconf:2508): Gtk-WARNING ** GtkSpinbutton: setting an adjustment with non-zero page size is deprectated
                             Error: no operation specified
                             Warning: locale not supported by C library, locale unchanged

The first line repeats six times, the second only once, the third line 3 times.

mattfitz

Member

Registered: 2008-10-27

Posts: 27

Re: Openbox crashes when I go to another VC and then switch back.

For me openbox (or any wm) runs in vc/7 . I've noticed those types of error messages before, and I assumed they were just inconsequential incompatibilties between the gtk theme and the engine.  They get spit out if I start a program from a terminal emulator, or in vc/1 if i start x via startx (which I assume you are doing). At any rate, just try going to vc/7.