Arch Linux

russianwizard

Member

From: Louisville KY

Registered: 2009-03-21

Posts: 39

installed wicd, conky does not display ip on the correct interface

I installed wicd, which works great. But now conky shows the ip for the opposite interface than the one it is connected to. For instance whenever I connect to a wired network (eth0) it will display the ip under eth1, and vice versa. Ive used the same .conkyrc file on all my machines (With a few changes to drive status bars and cpu graphs) and it works fine except for this small setting on my laptop.

---

SONY VAIO VGN-FS630/W, 1.73Ghz Pentium M, 512mb RAM (Intel 915GM) (Ubuntu 9.04, Arch & BT3)