I'm installing Arch on an HP Vectra with a single 4 GB Hard drive. I edited the GRUB configuration file, and tried to boot the computer to Arch. After the BIOS splash screen, the screen goes black, and then the word GRUB appears at the top left of the screen, and won't change from then on. Is this an obvious problem? What am I doing wrong?
are you sure it's i686?
And where were all the sportsmen who always pulled you though?
They're all resting down in Cornwall
writing up their memoirs for a paper-back edition
of the Boy Scout Manual.
You may try lilo, first, and later replace it with grub.
Frumpus ♥ addict