You are not logged in.
I'm trying to follow the dri building guide but archlinux doesn't have /etc/modules.conf so what do I do?
2.6.x kernels:
pre-install <drm module> /sbin/modprobe "-k" "agpgart"
pre-install agpgart /sbin/modprobe "-k" "<agp chipset driver>"
Thats what I'm trying to do. For more info go here:
http://dri.freedesktop.org/wiki/Buildin … 16c0c945a7
I don't know if I should make a /etc/modules.conf or add what to what. Specific instructions would be great. Btw i have a via chipset (vt8237) and an ati radeon (9800 pro) graphics card. Thanks in advance.
btw correct me if I'm wrong:
/etc/rc.conf:
LOCALE="en_US.utf8"
HARDWARECLOCK="UTC"
USEDIRECTISA="no"
TIMEZONE="America/Chicago"
KEYMAP="us"
CONSOLEFONT=
CONSOLEMAP=
USECOLOR="yes"
#not sure if a line in MODULES=(...) should be made or not
MOD_AUTOLOAD="yes"
MODULES=(pre-install radeon /sbin/modprobe "-k" "agpgart"
pre-install agpgart /sbin/modprobe "-k" "via_agp")
USELVM="no"
HOSTNAME="archie"
eth0="eth0 192.168.0.10 netmask 255.255.255.0 broadcast 192.168.0.255"
INTERFACES=(eth0)
gateway="default gw 192.168.0.1"
ROUTES=(gateway)
DAEMONS=(!syslog-ng !netfs !crond network hal fam alsa gdm)
Now what do I put in /etc/modprobe.conf (if anything) because I'm really confused
AMD Phenom II X4 955 with Optimized Kernel
5 GB DDR2 RAM
320 GB SATA Hard Drive + 160 GB SATA Hard Drive
ATi RadeonHD 5830 GIGABYTE
Offline
By default, the only modprobe.conf file that exists in a new install will be blank. The file is mostly used to either pass specific arguments to a kernel on boot-up so these args will be then inserted into userspace and used by whatever app needs them. EG: There are examples of this regarding Alsa and blacklisting or adding special arguments in modprobe.conf for the hda-intel on-board soundcards.
As to what to put into that file, I can't tell you (didn't read the link yet). I can tell you that you likely should just create it first then re-read what you're trying to do. These lines won't go into rc.conf, that much I know:
pre-install <drm module> /sbin/modprobe "-k" "agpgart"
pre-install agpgart /sbin/modprobe "-k" "<agp chipset driver>"
In all likelihood you must either insert these into the modprobe.conf file itself OR run them as root commands. As I said, haven't read the link so I don't know for sure. Sorry, and I don't have time to read up much more.
HTH
MS
Offline