You are not logged in.
Pages: 1
I have a compaq presario V5000 with a broken screen that I'd like to use my Sanyo TV with. I have the S-Video hooked up, and it lists it in xrandr (and flickers when I type xrandr!), but nothing is showing on it. I'm using the xf86-video-intel driver and when I open lxrandr, select "Turn On" for the TV, it closes but nothing happens and it's not selected when I reopen lxrandr. Here's the output of some relative commands, maybe someone can point me in the right direction?
xrandr -
Screen 0: minimum 320 x 200, current 1280 x 960, maximum 1440 x 1440
VGA connected 1280x960+0+0 (normal left inverted right x axis y axis) 410mm x 257mm
1280x960 60.0*+
1440x900 59.9 + 75.0 59.9
1280x1024 75.0 60.0
1152x864 75.0
1024x768 75.0 70.1 60.0
832x624 74.6
800x600 72.2 75.0 60.3 56.2
640x480 75.0 72.8 66.7 59.9
720x400 70.1
LVDS connected 1280x800+0+0 (normal left inverted right x axis y axis) 330mm x 210mm
1280x800 60.1*+
1024x768 60.0
800x600 60.3
640x480 59.9
TV connected (normal left inverted right x axis y axis)
1024x768 30.0
800x600 30.0
848x480 30.0
640x480 30.0
lspci | grep VGA
00:02.0 VGA compatible controller: Intel Corporation Mobile 945GM/GMS, 943/940GML Express Integrated Graphics Controller (rev 03)
dnyy in IRC & Urban Terror
Offline
The graphics adaptor on my Thinkpad R60 is the same. There is only the S-video connector. I rember having a similiar issue with tv-out on an ATI graphics card. The option there was to provide a TV compatible resolution / freq. setting and connect the graphics card to the TV. ie. for NTSC you would use something like 800x600 and 60Hz.
It's some time ago. Have you been lucky on this?
Offline
Pages: 1