You are not logged in.

#1 2009-07-14 05:17:48

sveri80
Member
Registered: 2008-11-12
Posts: 38

cannot start Enemy territory QT

Hi Folks,

when i read the thread about FPS i saw ETQW mentioned and thought, uhm, that was a great game, i should install it again and start playing a bit.
Thought, done, but when i try to start it i get the following error:
------------------
Initializing SDL subsystem
Loading GL driver 'libGL.so.1' through SDL
WARNING: SDL_GL_LoadLibrary libGL.so.1 failed: Failed loading libGL.so.1

------- Initializing renderSystem --------
----- R_InitOpenGL -----
signal caught: 'Segmentation fault', si_code 1
callstack:
0x0
[0x082e6001]
[0x082e340d]
[0xf7f44410]
Trying to exit gracefully..
--------------- BSE Shutdown ----------------
---------------------------------------------
Shutting down SDL subsystem
idRenderSystem::Shutdown()
----------------

I am using the proprietary catalyst driver and i think this is the problem?
However,  any ideas how i can solve it?


Greetings
Sven

Offline

#2 2009-07-14 14:52:15

Gen2ly
Member
From: Sevierville, TN
Registered: 2009-03-06
Posts: 1,529
Website

Re: cannot start Enemy territory QT

Take a look at the AUR page.  I don't know but there is a post that talks bout using a different opengl catalyst-package.


Setting Up a Scripting Environment | Proud donor to wikipedia - link

Offline

Board footer

Powered by FluxBB