Arch Linux

patrickaupperle

Member

Registered: 2008-12-11

Posts: 71

Kodak EasyShare CX7300

I have a Kodak EasyShare CX7300 digital camera. It is detected by KDE, digikam, lsusb, and gphoto. Beyond that, I can not do anything. None of the programs mentioned before can access anything on the camera. Any Ideas?

[patrick@arch ~]$ gphoto2 --auto-detect
Model                          Port
----------------------------------------------------------
Kodak CX7300                   usb:
[patrick@arch ~]$ lsusb
Bus 004 Device 002: ID 040a:0578 Kodak Co. CX7300/CX7310
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
[patrick@arch ~]$

patrickaupperle

Member

Registered: 2008-12-11

Posts: 71

Re: Kodak EasyShare CX7300

here is tail /var/log/messages.log. I think most of that came from the fact that I have been unplugging the camera and plugging it back in.

[patrick@arch ~]$ sudo tail /var/log/messages.log
Oct 18 16:05:13 arch kernel: usb 3-1: configuration #1 chosen from 1 choice
Oct 18 16:05:13 arch load-modules.sh: 'usb:v040Ap0578d0100dc00dsc00dp00ic06isc01ip01' is not a valid module or alias name
Oct 18 16:13:20 arch kernel: usb 3-1: USB disconnect, address 8
Oct 18 16:13:26 arch kernel: usb 4-1: new full speed USB device using uhci_hcd and address 2
Oct 18 16:13:27 arch kernel: usb 4-1: configuration #1 chosen from 1 choice
Oct 18 16:13:27 arch load-modules.sh: 'usb:v040Ap0578d0100dc00dsc00dp00ic06isc01ip01' is not a valid module or alias name
Oct 18 16:28:22 arch kernel: usb 4-1: USB disconnect, address 2
Oct 18 16:28:34 arch kernel: usb 4-1: new full speed USB device using uhci_hcd and address 3
Oct 18 16:28:34 arch kernel: usb 4-1: configuration #1 chosen from 1 choice
Oct 18 16:28:34 arch load-modules.sh: 'usb:v040Ap0578d0100dc00dsc00dp00ic06isc01ip01' is not a valid module or alias name
[patrick@arch ~]$

Hope this helps you all solve the problem.

Last edited by patrickaupperle (2009-10-18 21:43:44)

patrickaupperle

Member

Registered: 2008-12-11

Posts: 71

Re: Kodak EasyShare CX7300

Has anyone had a similar problem with a different camera? That solution might work here, too!