You are not logged in.
Pages: 1
I've got a 6x8 Genius tablet and I installed the wizardpen driver from the AUR. It seemed to work perfectly after a fresh reboot but a few minutes later I noticed it had stopped working for no obvious reason. The small LED at the top blinks on and off and "grep -i name /proc/bus/input/devices" doesn't show it's name in the list returned.
$ grep -i name /proc/bus/input/devices
N: Name="Macintosh mouse button emulation"
N: Name="AT Translated Set 2 keyboard"
N: Name="PC Speaker"
N: Name="Power Button"
N: Name="Power Button"
N: Name="ImPS/2 Logitech Wheel Mouse"
N: Name="HDA Digital PCBeep"
Any help would be appreciated!
Offline
After trying to get it to work for several more hours I realized that "dmsg" was replying with this when I plugged in the tablet:
usb 2-6: new low speed USB device using ohci_hcd and address 40
usb 2-6: device descriptor read/64, error -62
usb 2-6: device descriptor read/64, error -62
usb 2-6: new low speed USB device using ohci_hcd and address 41
usb 2-6: device descriptor read/64, error -62
usb 2-6: device descriptor read/64, error -62
usb 2-6: new low speed USB device using ohci_hcd and address 42
usb 2-6: device not accepting address 42, error -62
usb 2-6: new low speed USB device using ohci_hcd and address 43
usb 2-6: device not accepting address 43, error -62
hub 2-0:1.0: unable to enumerate USB device on port 6
Does this mean my tablet's broken? ):
Offline
Does this mean my tablet's broken? ):
I supposed you figured out so far. I'm just announcing here that I updated the driver to the last version so people who check the forum about a problem can try it.
Offline
Pages: 1