You are not logged in.
Pages: 1
I am incapable of writing cd's or dvds. cds fail right away but i have managed to burn a dvd at speed 0.3x way to slow.
k3b output:
System
-----------------------
K3b Version: 1.69.0
KDE Version: 4.3.95 (KDE 4.3.95 (KDE 4.4 RC2))
QT Version: 4.6.1
Kernel: 2.6.33-rc4-rc4
Used versions
-----------------------
mkisofs: 1.1.10
cdrecord: 1.1.10
cdrecord
-----------------------
scsidev: '/dev/sr0'
devname: '/dev/sr0'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Wodim version: 1.1.10
SCSI buffer size: 64512
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
TOC Type: 3 = CD-ROM XA mode 2
Driveropts: 'burnfree'
Device type : Removable CD-ROM
Version : 5
Response Format: 2
Capabilities :
Vendor_info : 'HL-DT-ST'
Identification : 'DVD+-RW GA11N '
Revision : 'A102'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009 (CD-R)
Profile: 0x0012 (DVD-RAM)
Profile: 0x0011 (DVD-R sequential recording)
Profile: 0x0015 (DVD-R/DL sequential recording)
Profile: 0x0014 (DVD-RW sequential recording)
Profile: 0x0013 (DVD-RW restricted overwrite)
Profile: 0x001A (DVD+RW)
Profile: 0x001B (DVD+R)
Profile: 0x002B (DVD+R/DL)
Profile: 0x0010 (DVD-ROM)
Profile: 0x0009 (CD-R) (current)
Profile: 0x000A (CD-RW)
Profile: 0x0008 (CD-ROM)
Profile: 0x0002 (Removable disk)
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1053696 = 1029 KB
Drive DMA Speed: 15215 kB/s 86x CD 10x DVD
FIFO size : 4194304 = 4096 KB
Speed set to 2822 KB/s
Track 01: data 93 MB
Total size: 107 MB (10:39.46) = 47960 sectors
Lout start: 107 MB (10:41/35) = 47960 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 5
Is not unrestricted
Is not erasable
Disk sub type: Medium Type A, high Beta category (A+) (3)
ATIP start of lead in: -11634 (97:26/66)
ATIP start of lead out: 359846 (79:59/71)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 3
Manufacturer: CMC Magnetics Corporation
Blocks total: 359846 Blocks current: 359846 Blocks remaining: 311886
Starting to write CD/DVD at speed 16.0 in real TAO mode for multi session.
Last chance to quit, starting real write in 2 seconds.
1 seconds.
0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
Starting new track at sector: 0
Track 01: 0 of 93 MB written.
Track 01: 1 of 93 MB written (fifo 100%) [buf 99%] 0.4x.
Errno: 5 (Input/output error), write_g1 scsi sendcmd: no error
CDB: 2A 00 00 00 02 0F 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0A 2A 30 02 80 21 02 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x21 Qual 0x02 (invalid address for write) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.003s timeout 40s
/usr/bin/wodim: The current problem looks like a buffer underrun.
/usr/bin/wodim: It looks like 'driveropts=burnfree' does not work for this drive.
/usr/bin/wodim: Please report.
/usr/bin/wodim: Make sure that you are root, enable DMA and check your HW/OS set up.
write track data: error after 1079296 bytes
Writing time: 25.131s
Average write speed 25.5x.
Min drive buffer fill was 99%
Fixating...
Fixating time: 27.574s
/usr/bin/wodim: fifo had 81 puts and 18 gets.
/usr/bin/wodim: fifo was 0 times empty and 7 times full, min fill was 92%.any thoughts?
Offline
after a lot of searching it seems to be a firmware issue, Note to others: Dell XPS 1645 might not burn cd/dvds for you.
Offline
Pages: 1