You are not logged in.

#1 2010-01-31 18:01:52

ozgun_gor
Member
Registered: 2010-01-22
Posts: 3

Adding hdd

I have added a hdd "fat32 full with personal data" to my pc. "FILESYSTEM CHECK FAILED" message is ocuring and Arch does not boot up.

The error says "The superblock could not be read or does not describe a correct ext2 filesystem. If the device is valid and it really contains an ext2 filesystem, the superblock is corrupt, and you might try using e2fsck with an alternate sueorblock e2fsck -b 8193"

Offline

#2 2010-01-31 18:11:55

Ramses de Norre
Member
From: Leuven - Belgium
Registered: 2007-03-27
Posts: 1,289

Re: Adding hdd

Not using persistent device naming? Probably your device nodes changed because you added the drive and the node assigned to your fat filesystem on the new drive is configured as an ext3 or ext4 filesystem in fstab.

Offline

Board footer

Powered by FluxBB