You are not logged in.
Pages: 1
hi guys,
I'm still trying to set up Arch.
So, I followed everything line per line the beginner's guide but I've a problem with STARTX.
When I run it, I get a Blackscreen and nothing happen, also if I press CTRL+ALT+DELETE nothing happens, if I press CTRL+ALT+F1 the screen "flash" one time but it's still black, if I press CTRL+ALT+DELETE the system reboot.
I installed VESA driver, then xorg -configure.
I also tried the INTEL driver or DUMMY but no luck.
I've a Intel 4500 MHD as video card.
If this can help, I was able to start the X server on Slackware 13 (x64), OpenSuse, Backtrack 3 & 4 and Debian.
Can you help me please?
Last edited by ripp3r (2010-05-17 11:50:21)
Offline
if this help:
Once removed the xorg.conf file from /etc/X11/ I can start the X server...
Seems to be ok...
I'll write again if I've problem otherwise I'll mark this thread as SOLVED
Offline
hey guy:
As far as I know,once you use open source drivers,it's useless to create a xorg.conf file,'cause xorg now could be started with the help of hal(or else?),and creating xorg.conf may cause some nerve-wrecking issues.Just remove that.You've done a great job.:)
This is the way the world ends
Not with a bang but a whimper
-------T·S·Eliot
Offline
hey guy:
As far as I know,once you use open source drivers,it's useless to create a xorg.conf file,'cause xorg now could be started with the help of hal(or else?),and creating xorg.conf may cause some nerve-wrecking issues.Just remove that.You've done a great job.:)
Yeah after well-reading the X man page I understood
Now everything works fine.
Offline
Pages: 1