You are not logged in.
Pages: 1
Hi, i have after fresh install, but my integrated networkcard is not working, eth0 on rc.conf is dhcp, resolv.conf i set to opendns.
My second OS Mandriva Linux on the same computer is connected to dhcp/opendns long time and working nice.
On archlinux /var/log/errors.log is eth0 interface is no such device.
I have this motherboard
http://www.msi.com/index.php?func=prodd … od_no=1499
hwdetect --show-net -> system dont know command hwdetect
I dont know what to do now, help :-(
Last edited by Cyl (2010-06-01 10:27:36)
Offline
what does ifconfig show?
Offline
lspci | grep Ethernet
Could also help determine if a specific module has to be used.
Offline
ifconfig
Link encap: Local Loopback
inet addr:127.0.0.1 Mask 255.0.0.0
Loopback running MTU:16436 Metric:1
and followed by lots of zeros for all items(packets, errors, collisions,....)
lspci | grep Ethernet
Ethernet Controller : nVidia corp. MCP73 Ethernet rev.a2
Offline
is the module "forcedeth" loaded?
Offline
i write lsmod and on results was not a forcedeth modul, i tried write him in to rc.conf modules, but after reboot and again lsmod i not found forcedeth on results again.
Offline
Try modprobe to load, and rmmod to remove modules at runtime
[toffyrn@hubble ~]$ sudo modprobe forcedeth
Password:
[toffyrn@hubble ~]$ lsmod | grep deth
forcedeth 47287 0
[toffyrn@hubble ~]$
After you have loaded the module, what is output of ifconfig then?
Last edited by toffyrn (2010-06-01 18:40:27)
Offline
Pages: 1