You are not logged in.
key repeat is not working at all. wondering what i'm doing wrong, or where the problem is. this is a pretty slim arch install; i installed the xorg group and xmonad, but no desktop (gnome, kde etc) env. other thing that might be an issue is that i pretty much only access this box via vnc and ssh.
i see the the command should be something like
xset r rate 10 1000
but that just returns an error saying xset: unknown option rate
issuing the command xset r and then xset q shows:
Keyboard Control:
auto repeat: on
but it still doesn't work.
that said, i haven't actually tried it in any way but via vnc, so maybe vnc is the problem? any suggestions?
thanks in advance!
Last edited by yagmot (2010-06-04 03:32:44)
Offline
bump. any ideas?
Offline
Are you sure about your command? It should read
xset r 10 1000i.e. no "rate" after the r option.
To know or not to know ...
... the questions remain forever.
Offline
not according to xset and everything i've read before. when i try the command as you typed it, xset gives me the default bad syntax/help message. towards the bottom it says
To turn auto-repeat off or on:
-r [keycode] r off
r [keycode] r on
r rate [delay [rate]]Offline
i went to the machine and fired up X there and it works fine. obviously it's something to do with the vnc server ![]()
Offline
You are right. According to man xset there is indeed a "rate" agument allowed in certain circumstances (I did never need it, though):
If the server supports the XFree86-Misc extension, or the XKB
extension, then a parameter of 'rate' is accepted and should be
followed by zero, one or two numeric values. The first speci‐
fies the delay before autorepeat starts and the second speci‐
fies the repeat rate. In the case that the server supports the
XKB extension, the delay is the number of milliseconds before
autorepeat starts, and the rate is the number of repeats per
second. If the rate or delay is not given, it will be set to
the default value.I don't know much about vnc, but this extension stuff could be the cause why it did not work.
To know or not to know ...
... the questions remain forever.
Offline
Since my latest Arch Linux installation---a few days ago---with just X but no desktop, keyboard autorepeat responds to settings such as 'xset r rate 500 20' buts stops autorepeating after a number of characters that varies randomly between zero and twenty or so (average a dozen). On virtual terminals it works fine. What can the matter be? Never seen before. Thanks
Last edited by rugantino (2012-04-05 22:36:36)
Offline