Arch Linux

Thorsten Reinbold

Member

From: Germany

Registered: 2011-12-06

Posts: 353

Strange issues with Liquorix Kernel (no network)

Hi all,

I have a strange problem with the Liquorix Kernel from AUR. It builded fine, without problems, but when I boot it I don't have network-access. I'm on an old Asus V6 (Pentium M, Centrino platform).

Some informations:

find /lib/modules/$(uname -r) -iname \*ipw2200\*

gives:

/lib/modules/3.1.0-lqx/kernel/drivers/net/wireless/ipw2x00/ipw2200.ko.gz

while modprobe

modporbe ipw2200

gives nothing.

dmesg:

cfg80211: Calling CRDA to update world regulatory domain
cfg80211: World regulatory domain updated:
cfg80211:     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
cfg80211:     (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
cfg80211:     (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
cfg80211:     (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
cfg80211:     (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
cfg80211:     (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
libipw: 802.11 data/management/control stack, git-1.1.13
libipw: Copyright (C) 2004-2005 Intel Corporation <jketreno@linux.intel.com>
ipw2200: Intel(R) PRO/Wireless 2200/2915 Network Driver, 1.2.2kmprq
ipw2200: Copyright(c) 2003-2006 Intel Corporation
ipw2200 0000:03:02.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
ipw2200: Detected Intel PRO/Wireless 2200BG Network Connection
cfg80211: failed to add phy80211 symlink to netdev!
ipw2200: Detected geography ZZM (11 802.11bg channels, 0 802.11a channels)
skge 0000:03:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18
skge: 1.14 addr 0xfbffc000 irq 18 chip Yukon-Lite rev 7
skge 0000:03:00.0: eth1: addr 00:11:d8:9f:df:f5
cfg80211: Calling CRDA for country: DE
cfg80211: Regulatory domain changed to country: DE
cfg80211:     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
cfg80211:     (2400000 KHz - 2483500 KHz @ 40000 KHz), (N/A, 2000 mBm)
cfg80211:     (5150000 KHz - 5250000 KHz @ 40000 KHz), (N/A, 2000 mBm)
cfg80211:     (5250000 KHz - 5350000 KHz @ 40000 KHz), (N/A, 2000 mBm)
cfg80211:     (5470000 KHz - 5725000 KHz @ 40000 KHz), (N/A, 2698 mBm)
NET: Registered protocol family 31
avahi-daemon[1998]: Found user 'avahi' (UID 84) and group 'avahi' (GID 84).
avahi-daemon[1998]: Successfully dropped root privileges.
avahi-daemon[1998]: avahi-daemon 0.6.30 starting up.
eth0: Setting MAC to 00:12:f0:5f:d0:83
ADDRCONF(NETDEV_UP): eth0: link is not ready
skge 0000:03:00.0: eth1: enabling interface
skge 0000:03:00.0: eth1: Link is up at 100 Mbps, full duplex, flow control both
eth1: no IPv6 routers present

Messages.log:

Dec  7 13:49:27 localhost NetworkManager[2084]: <info> Auto-activating connection 'Ethernet (automatisch)'.
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) starting connection 'Ethernet (automatisch)'
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> (eth0): device state change: disconnected -> prepare (reason 'none') [30 40 0]
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 1 of 5 (Device Prepare) scheduled...
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 1 of 5 (Device Prepare) started...
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 2 of 5 (Device Configure) scheduled...
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 1 of 5 (Device Prepare) complete.
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 2 of 5 (Device Configure) starting...
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> (eth0): device state change: prepare -> config (reason 'none') [40 50 0]
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 2 of 5 (Device Configure) successful.
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 3 of 5 (IP Configure Start) scheduled.
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 2 of 5 (Device Configure) complete.
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 3 of 5 (IP Configure Start) started...
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> (eth0): device state change: config -> ip-config (reason 'none') [50 70 0]
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Beginning DHCPv4 transaction (timeout in 45 seconds)
Dec  7 13:49:28 localhost dhcpcd[2425]: version 5.2.12 starting
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> dhcpcd started with pid 2425
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Beginning IP6 addrconf.
Dec  7 13:49:28 localhost avahi-daemon[1992]: Withdrawing address record for fe80::211:d8ff:fed0:76eb on eth0.
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 3 of 5 (IP Configure Start) complete.
Dec  7 13:49:28 localhost dhcpcd[2425]: eth0: rebinding lease of 192.168.1.57
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> (eth0): DHCPv4 state changed nbi -> preinit
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> (eth0): DHCPv4 state changed preinit -> fail
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 4 of 5 (IP4 Configure Timeout) scheduled...
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 4 of 5 (IP4 Configure Timeout) started...
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> (eth0): device state change: ip-config -> failed (reason 'ip-config-unavailable') [70 120 5]
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Marking connection 'Ethernet (automatisch)' invalid.
Dec  7 13:49:28 localhost NetworkManager[2084]: <warn> Activation (eth0) failed.
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> Activation (eth0) Stage 4 of 5 (IP4 Configure Timeout) complete.
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> (eth0): device state change: failed -> disconnected (reason 'none') [120 30 0]
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> (eth0): deactivating device (reason 'none') [0]
Dec  7 13:49:28 localhost dhcpcd[2425]: received SIGTERM, stopping
Dec  7 13:49:28 localhost dhcpcd[2425]: eth0: removing interface
Dec  7 13:49:28 localhost NetworkManager[2084]: <info> (eth0): canceled DHCP transaction, DHCP client pid 2425
Dec  7 13:49:28 localhost NetworkManager[2084]: <warn> (pid 2425) unhandled DHCP event for interface eth0

Does anybody know what goes wrong here?

Last edited by Thorsten Reinbold (2011-12-07 21:46:09)

Mavirick

Member

Registered: 2011-12-01

Posts: 62

Re: Strange issues with Liquorix Kernel (no network)

First I would disable IPv6 and then see if you are able to connect to the network.

https://wiki.archlinux.org/index.php/IP … the_Module

Last edited by Mavirick (2011-12-07 23:33:00)

Thorsten Reinbold

Member

From: Germany

Registered: 2011-12-06

Posts: 353

Re: Strange issues with Liquorix Kernel (no network)

No, this didn't changed anything. I've followed the steps in your link (Disable IPv6 during pre-init process), but it's the same as before.