You are not logged in.
Pages: 1
On startup as soon as the init scripts are done the screen blanks.
Other distros (like Gentoo) leave the ouput on vc1.
I would like to check the output of the init process (dmesg only shows the kernel output) ; how can I get to view this info. Or, better still how can i stop Arch clearning vc1 on boot?
Wiki Search = clear boot messages
Intel-D915GAV : Software Raid0 x 4 SATA : 1GB Ram : 3Ghz HT-P4
Offline
There is a page about "clear boot messages" on the wiki but it is down at the moment
Offline
There is a page about "clear boot messages" on the wiki but it is down at the moment
Thanks, i'll check it out when its backup.
Intel-D915GAV : Software Raid0 x 4 SATA : 1GB Ram : 3Ghz HT-P4
Offline
Pages: 1