You are not logged in.

#1 2012-01-15 04:28:26

geoffm
Member
Registered: 2012-01-15
Posts: 30

SQUASHFS error when bootin netinstall from USB

I copied archlinux-2011.08.19-netinstall-x86_64 on a 256MB USB flash drive using dd.
When I boot it it boots normally except for several error messages that appear saying:

### SQUASHFS ERROR unable to read data cache entry ###
### SQUASHFS ERROR unable to read page block ###

the ### numbers change every line. a dozen of these appear then booting resumes and it gets to the command line. I tried setting the keyboard and loading the installer, so far it seems normal.

Can someone tell what the nature of this error message is? Could it be just because I burnt the iso on a smaller disk than it is intended for and it should work properly? Or does it mean the data is corrupted and I should not use it for install?

Offline

#2 2012-01-29 15:05:49

Svinto
Member
Registered: 2012-01-15
Posts: 18

Re: SQUASHFS error when bootin netinstall from USB

I got the same error.

Using archlinux-2011.08.19-netinstall-dual.iso from USB.
Prepared the USB stick from Windows using "Disk Imager", as per instructions from the guide (https://wiki.archlinux.org/index.php/Be … _USB_stick).

It occurs on my laptop when booting with x86_64.
If I boot with i686 I get no errors.

When booting with x86_64, "waiting for udev" and "activating swap" fails. I also see a lot of these messages:

### SQUASHFS ERROR unable to read data cache entry ###
### SQUASHFS ERROR unable to read page block ###

Other than this, everything seems to work, except creating encrypted partitions with dm_crypt and lvm with "/arch/setup". After setting the password everything errors out. Also no problem if I do this in i686.

Last edited by Svinto (2012-01-29 15:07:19)

Offline

Board footer

Powered by FluxBB