Arch Linux

fr1tz

Member

From: La Mancha

Registered: 2012-01-09

Posts: 7

grub2 installation and aif network config

Trying to install grub2 after exiting the arch installer and with no other bootloader currently installed. Following the steps on the grub2 wiki page but cannot get a network connection after chrooting. The wiki says I should copy /etc/resolv.conf to /tmp/install but this directory does not exist. Should it?

guelfi

Member

From: /home/guelfi

Registered: 2011-07-01

Posts: 111

Re: grub2 installation and aif network config

You should copy it to whatever place you mounted the hard disk, /mnt in the case
of the wiki. I suppose that in an earlier version of the setup, /tmp/install was
used as the mount point of the new system's hard disk, but it was changed and
someone forgot to change this command. Of course, if you understood what you're
doing there and read the following paragraph, you could figure it out by yourself.

fr1tz

Member

From: La Mancha

Registered: 2012-01-09

Posts: 7

Re: grub2 installation and aif network config

Thanks. This is what I suspected but was just clarifying. Should probably update the wiki.